In some cases the standby/enable gpio can be pulled low/high and would not
be connected to a gpio. The current driver implementation will return an
error in these cases. Therefore, make devm_gpiod_get optional.
Signed-off-by: Aswath Govindraju <a-govindraju@xxxxxx>
---
drivers/phy/phy-can-transceiver.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/phy/phy-can-transceiver.c b/drivers/phy/phy-can-transceiver.c
index c2cb93b4df71..6f3fe37dee0e 100644
--- a/drivers/phy/phy-can-transceiver.c
+++ b/drivers/phy/phy-can-transceiver.c
@@ -110,14 +110,14 @@ static int can_transceiver_phy_probe(struct platform_device *pdev)
can_transceiver_phy->generic_phy = phy;
if (drvdata->flags & CAN_TRANSCEIVER_STB_PRESENT) {
- standby_gpio = devm_gpiod_get(dev, "standby", GPIOD_OUT_HIGH);
+ standby_gpio = devm_gpiod_get_optional(dev, "standby", GPIOD_OUT_HIGH);
if (IS_ERR(standby_gpio))
return PTR_ERR(standby_gpio);
can_transceiver_phy->standby_gpio = standby_gpio;
}
if (drvdata->flags & CAN_TRANSCEIVER_EN_PRESENT) {
- enable_gpio = devm_gpiod_get(dev, "enable", GPIOD_OUT_LOW);
+ enable_gpio = devm_gpiod_get_optional(dev, "enable", GPIOD_OUT_LOW);
if (IS_ERR(enable_gpio))
return PTR_ERR(enable_gpio);
can_transceiver_phy->enable_gpio = enable_gpio;
--
2.17.1
