Re: ethtool: ring configuration for CAN devices

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



> > struct ethtool_kringparam {
> > 	__u32	cmd;
> > 	__u32   mode;
> > 	__u32	rx_max_pending;
> > 	__u32	rx_mini_max_pending;
> > 	__u32	rx_jumbo_max_pending;
> > 	__u32	tx_max_pending;
> > 	__u32	rx_pending;
> > 	__u32	rx_mini_pending;
> > 	__u32	rx_jumbo_pending;
> > 	__u32	tx_pending;
> > };
> > 
> > and use this structure between the ethtool core and the drivers. This
> > has already been done at least once to allow extending the
> > API. Semantic patches are good for making the needed changes to all
> > the drivers.
> 
> What about the proposed "two new parameters ringparam_ext and extack for
> .get_ringparam and .set_ringparam to extend more ring params through
> netlink." by Hao Chen/Guangbin Huang in:
> 
> https://lore.kernel.org/all/20211014113943.16231-5-huangguangbin2@xxxxxxxxxx/
>
> I personally like the conversion of the in in-kernel API to struct
> ethtool_kringparam better than adding ringparam_ext.

Ah, i missed that development. I don't like it.

You should probably jump into that discussion and explain your
requirements. Make sure it is heading in a direction you can extend
for your needs.

    Andrew



[Index of Archives]     [Automotive Discussions]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]     [CAN Bus]

  Powered by Linux