On 22/01/20 7:05 PM, Dan Murphy wrote: > Faiz > > On 1/22/20 2:03 AM, Faiz Abbas wrote: >> The CAN transceiver on some boards has an STB pin which is >> used to control its standby mode. Add an optional property >> stb-gpios to toggle the same. >> >> Signed-off-by: Faiz Abbas <faiz_abbas@xxxxxx> >> Signed-off-by: Sekhar Nori <nsekhar@xxxxxx> >> --- >> Documentation/devicetree/bindings/net/can/m_can.txt | 2 ++ >> 1 file changed, 2 insertions(+) >> >> diff --git a/Documentation/devicetree/bindings/net/can/m_can.txt >> b/Documentation/devicetree/bindings/net/can/m_can.txt >> index ed614383af9c..cc8ba3f7a2aa 100644 >> --- a/Documentation/devicetree/bindings/net/can/m_can.txt >> +++ b/Documentation/devicetree/bindings/net/can/m_can.txt >> @@ -48,6 +48,8 @@ Optional Subnode: >> that can be used for CAN/CAN-FD modes. See >> >> Documentation/devicetree/bindings/net/can/can-transceiver.txt >> for details. >> +stb-gpios : gpio node to toggle the STB (standby) signal on >> the transceiver >> + > > The m_can.txt is for the m_can framework. If this is specific to the > platform then it really does not belong here. > > If the platform has specific nodes then maybe we need a > m_can_platform.txt binding for specific platform nodes. But I leave > that decision to Rob. Since this is transceiver enable, should this not be in Documentation/devicetree/bindings/net/can/can-transceiver.txt? Thanks, Sekhar
