From: Dan Murphy <dmurphy@xxxxxx>
The wake-up of the device can be configured as an optional feature of
the device. Move the wake-up gpio from a requried property to an
optional property.
Signed-off-by: Dan Murphy <dmurphy@xxxxxx>
Cc: Rob Herring <robh@xxxxxxxxxx>
Reviewed-by: Sean Nyekjaer <sean@xxxxxxxxxx>
Tested-by: Sean Nyekjaer <sean@xxxxxxxxxx>
Signed-off-by: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx>
---
Documentation/devicetree/bindings/net/can/tcan4x5x.txt | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
index e8aa21d9174e..6bdcc3f84bd3 100644
--- a/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
+++ b/Documentation/devicetree/bindings/net/can/tcan4x5x.txt
@@ -10,7 +10,6 @@ Required properties:
- #size-cells: 0
- spi-max-frequency: Maximum frequency of the SPI bus the chip can
operate at should be less than or equal to 18 MHz.
- - device-wake-gpios: Wake up GPIO to wake up the TCAN device.
- interrupt-parent: the phandle to the interrupt controller which provides
the interrupt.
- interrupts: interrupt specification for data-ready.
@@ -23,6 +22,7 @@ Optional properties:
reset.
- device-state-gpios: Input GPIO that indicates if the device is in
a sleep state or if the device is active.
+ - device-wake-gpios: Wake up GPIO to wake up the TCAN device.
Example:
tcan4x5x: tcan4x5x@0 {
--
2.24.0
