> -----Original Message----- > From: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> > Sent: 2019年12月7日 22:11 > To: Joakim Zhang <qiangqing.zhang@xxxxxxx>; sean@xxxxxxxxxx; > linux-can@xxxxxxxxxxxxxxx > Cc: dl-linux-imx <linux-imx@xxxxxxx>; netdev@xxxxxxxxxxxxxxx > Subject: Re: [PATCH V3 0/6] can: flexcan: fixes for stop mode > > On 12/4/19 12:36 PM, Joakim Zhang wrote: > > Hi Marc, > > > > I removed the patch (can: flexcan: try to exit stop mode during > > probe stage) out of this patch set for now. This patch should further > > discuss with Sean and I will prepare it according to final conclusion. Thanks. > > > > Regards, > > Joakim Zhang > > > > Joakim Zhang (5): > > can: flexcan: Ack wakeup interrupt separately > > can: flexcan: add low power enter/exit acknowledgment helper > > can: flexcan: change the way of stop mode acknowledgment > > Above 3 applied to linux-can. Hi Marc, >From below link, I have not found the patch: can: flexcan: Ack wakeup interrupt separately https://git.kernel.org/pub/scm/linux/kernel/git/mkl/linux-can.git/log/?h=linux-can-fixes-for-5.5-20191208 > > can: flexcan: propagate error value of flexcan_chip_stop() > > can: flexcan: add LPSR mode support > > Above 2 applied to linux-can-next I also have not found these two patch on linux-can-next, which branch has you pushed? Thanks. Best Regards, Joakim Zhang > Marc > -- > Pengutronix e.K. | Marc Kleine-Budde | > Embedded Linux | https://www.pengutronix.de | > Vertretung West/Dortmund | Phone: +49-231-2826-924 | > Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
