This fixes some double-word and trivial typos in the ucan driver comments.
Signed-off-by: Martin Kepplinger <martink@xxxxxxxxx>
---
hi guys,
The Seal looks very nice. Since I'm doing CAN work right now, I could totally
use one of these instead of old gear from PEAK.
I hope you're doing fine. Best regards,
martin
drivers/net/can/usb/ucan.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)
diff --git a/drivers/net/can/usb/ucan.c b/drivers/net/can/usb/ucan.c
index 0678a38b1af4..8c680fb9fdc8 100644
--- a/drivers/net/can/usb/ucan.c
+++ b/drivers/net/can/usb/ucan.c
@@ -64,7 +64,7 @@
* the following way:
*
* m[n].len <=> the length if message n(including the header in bytes)
- * m[n] is is aligned to a 4 byte boundary, hence
+ * m[n] is aligned to a 4 byte boundary, hence
* offset(m[0]) := 0;
* offset(m[n+1]) := offset(m[n]) + (m[n].len + 3) & 3
*
@@ -288,7 +288,7 @@ struct ucan_priv {
*/
spinlock_t echo_skb_lock;
- /* usb device information information */
+ /* usb device information */
u8 intf_index;
u8 in_ep_addr;
u8 out_ep_addr;
@@ -1449,7 +1449,7 @@ static int ucan_probe(struct usb_interface *intf,
/* request the device information and store it in ctl_msg_buffer
*
- * note: ucan_ctrl_command_* wrappers connot be used yet
+ * note: ucan_ctrl_command_* wrappers cannot be used yet
* because `up` is initialised in Stage 3
*/
ret = usb_control_msg(udev,
@@ -1498,7 +1498,7 @@ static int ucan_probe(struct usb_interface *intf,
up = netdev_priv(netdev);
- /* initialze data */
+ /* initialize data */
up->udev = udev;
up->intf = intf;
up->netdev = netdev;
--
2.19.0
