Always prevent trying to set device baudrate before calling setup() when
using autobaud mode.
This was previously happening for devices which had device specific data
with member no_early_set_baudrate set to 0.
Signed-off-by: Hakan Jansson <hakan.jansson@xxxxxxxxxxxx>
Reviewed-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
V1 -> V2:
- No changes, submitted as part of updated patch series
drivers/bluetooth/hci_bcm.c | 5 +----
1 file changed, 1 insertion(+), 4 deletions(-)
diff --git a/drivers/bluetooth/hci_bcm.c b/drivers/bluetooth/hci_bcm.c
index 9a129867a4c0..0ae627c293c5 100644
--- a/drivers/bluetooth/hci_bcm.c
+++ b/drivers/bluetooth/hci_bcm.c
@@ -484,7 +484,7 @@ static int bcm_open(struct hci_uart *hu)
/* If oper_speed is set, ldisc/serdev will set the baudrate
* before calling setup()
*/
- if (!bcm->dev->no_early_set_baudrate)
+ if (!bcm->dev->no_early_set_baudrate && !bcm->dev->use_autobaud_mode)
hu->oper_speed = bcm->dev->oper_speed;
err = bcm_gpio_set_power(bcm->dev, true);
@@ -1204,9 +1204,6 @@ static int bcm_of_probe(struct bcm_device *bdev)
{
bdev->use_autobaud_mode = device_property_read_bool(bdev->dev,
"brcm,requires-autobaud-mode");
- if (bdev->use_autobaud_mode)
- bdev->no_early_set_baudrate = true;
-
device_property_read_u32(bdev->dev, "max-speed", &bdev->oper_speed);
device_property_read_u8_array(bdev->dev, "brcm,bt-pcm-int-params",
bdev->pcm_int_params, 5);
--
2.25.1
