On 6/9/2022 7:09 PM, Zijun Hu wrote:
> It will set up SCO after all CVSD eSCO attempts failure, but
> still fails to set up SCO finally due to wrong D1/D0 @retrans_effort
> within @esco_param_cvsd, so change it from 0x1 to 0xff to avoid
> Invalid HCI Command Parameters error.
>
> < HCI Command: Setup Synchrono.. (0x01|0x0028) plen 17 #3427
> Handle: 3
> Transmit bandwidth: 8000
> Receive bandwidth: 8000
> Max latency: 65535
> Setting: 0x0060
> Input Coding: Linear
> Input Data Format: 2's complement
> Input Sample Size: 16-bit
> # of bits padding at MSB: 0
> Air Coding Format: CVSD
> Retransmission effort: Optimize for power consumption (0x01)
> Packet type: 0x03c4
> HV3 may be used
> 2-EV3 may not be used
> 3-EV3 may not be used
> 2-EV5 may not be used
> 3-EV5 may not be used
>> HCI Event: Command Status (0x0f) plen 4 #3428
> Setup Synchronous Connection (0x01|0x0028) ncmd 1
> Status: Success (0x00)
>> HCI Event: Synchronous Connect Comp.. (0x2c) plen 17 #3429
> Status: Invalid HCI Command Parameters (0x12)
> Handle: 0
> Address: 14:3F:A6:47:56:15 (OUI 14-3F-A6)
> Link type: SCO (0x00)
> Transmission interval: 0x00
> Retransmission window: 0x00
> RX packet length: 0
> TX packet length: 0
> Air mode: u-law log (0x00)
>
> Signed-off-by: Zijun Hu <quic_zijuhu@xxxxxxxxxxx>
> ---
> net/bluetooth/hci_conn.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/net/bluetooth/hci_conn.c b/net/bluetooth/hci_conn.c
> index 7829433d54c1..2627d5ac15d6 100644
> --- a/net/bluetooth/hci_conn.c
> +++ b/net/bluetooth/hci_conn.c
> @@ -45,8 +45,8 @@ static const struct sco_param esco_param_cvsd[] = {
> { EDR_ESCO_MASK & ~ESCO_2EV3, 0x000a, 0x01 }, /* S3 */
> { EDR_ESCO_MASK & ~ESCO_2EV3, 0x0007, 0x01 }, /* S2 */
> { EDR_ESCO_MASK | ESCO_EV3, 0x0007, 0x01 }, /* S1 */
> - { EDR_ESCO_MASK | ESCO_HV3, 0xffff, 0x01 }, /* D1 */
> - { EDR_ESCO_MASK | ESCO_HV1, 0xffff, 0x01 }, /* D0 */
> + { EDR_ESCO_MASK | ESCO_HV3, 0xffff, 0xff }, /* D1 */
> + { EDR_ESCO_MASK | ESCO_HV1, 0xffff, 0xff }, /* D0 */
> };
>
> static const struct sco_param sco_param_cvsd[] = {
could you code review for this change?
