Hi, On Wed, Jun 23, 2021 at 11:43 AM Luiz Augusto von Dentz <luiz.dentz@xxxxxxxxx> wrote: > > From: Luiz Augusto von Dentz <luiz.von.dentz@xxxxxxxxx> > > This introduces AuthenticationFailed method which is used to indicate > when there was an authentication failure with a remote device which is > recommended by the core spec: > > BLUETOOTH CORE SPECIFICATION Version 5.2 | Vol 3, Part C page 1314: > '5.2.2.3 Simple Pairing after authentication failure > When the link key is stored, subsequent connections to the same device > will use authentication but this may fail if the remote device has > deleted the link key. Table 5.2 defines what shall be done depending > on the type of the link key and whether bonding was performed or not.' > > So following Table 5.2 recommendation the AuthenticationFailed method > would be called when authentication fails with a bonded device. This was intended to be an RFC. > --- > doc/agent-api.txt | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/doc/agent-api.txt b/doc/agent-api.txt > index 0d9347cab..91d752b0a 100644 > --- a/doc/agent-api.txt > +++ b/doc/agent-api.txt > @@ -183,3 +183,8 @@ Methods void Release() > > This method gets called to indicate that the agent > request failed before a reply was returned. > + > + void AuthenticationFailed(object device, byte status) > + > + This method indicates that there was an authentication > + failure with a remote device. > -- > 2.31.1 > -- Luiz Augusto von Dentz
