Add Controller Suspend Event and Controller Resume Event to identify suspend or resume of the Bluetooth stack has occurred. Also update Device Disconnected Event to indicate a new disconnect reason: "Connection terminated by local host for suspend" Reviewed-by: Alain Michaud <alainm@xxxxxxxxxxxx> Reviewed-by: Miao-chen Chou <mcchou@xxxxxxxxxxxx> --- Re-sending along with kernel changes. Changes in v2: - Moved Wake_Reason to first value - Reduced Wake_Reason to not Bluetooth, unexpected event and remote wake doc/mgmt-api.txt | 48 ++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+) diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt index ca0d38469..e7a713824 100644 --- a/doc/mgmt-api.txt +++ b/doc/mgmt-api.txt @@ -3834,6 +3834,7 @@ Device Disconnected Event 2 Connection terminated by local host 3 Connection terminated by remote host 4 Connection terminated due to authentication failure + 5 Connection terminated by local host for suspend Note that the local/remote distinction just determines which side terminated the low-level connection, regardless of the @@ -4577,3 +4578,50 @@ Advertisement Monitor Removed Event The event will only be sent to management sockets other than the one through which the command was sent. + + +Controller Suspend Event +======================== + + Event code: 0x002d + Controller Index: <controller_id> + Event Parameters: Suspend_State (1 octet) + + This event indicates that the controller is suspended for host suspend. + + Possible values for the Suspend_State parameter: + 0 Running (not disconnected) + 1 Disconnected and not scanning + 2 Page scanning and/or passive scanning. + + The value 0 is used for the running state and may be sent if the + controller could not be configured to suspend properly. + + This event will be sent to all management sockets. + + +Controller Resume Event +======================= + + Event code: 0x002e + Controller Index: <controller_id> + Event Parameters: Wake_Reason (1 octet) + Address (6 octets) + Address_Type (1 octet) + + This event indicates that the controller has resumed from suspend. + + Possible values for the Wake_Reason parameter: + 0 Resume from non-Bluetooth wake source + 1 Wake due to unexpected event + 2 Remote wake due to peer device connection + + Currently, we expect that only peer reconnections should wake us from + the suspended state. Any other events that occurred while the system + should have been suspended results in wake due to unexpected event. + + If the Wake_Reason is Remote wake due to connection, the address of the + peer device that caused the event will be shared in Address and + Address_Type. Otherwise, Address and Address_Type will both be zero. + + This event will be sent to all management sockets. -- 2.28.0.618.gf4bc123cb7-goog
