Hi Zijun, > Warm reboot can not restore qca6390 controller baudrate > to default due to lack of controllable BT_EN pin or power > supply, so fails to download firmware after warm reboot. > > Fixed by sending EDL_SOC_RESET VSC to reset controller > within added device shutdown implementation. > > Signed-off-by: Zijun Hu <zijuhu@xxxxxxxxxxxxxx> > --- > drivers/bluetooth/hci_qca.c | 33 +++++++++++++++++++++++++++++++++ > 1 file changed, 33 insertions(+) > > diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c > index e4a6823..8e03bfe 100644 > --- a/drivers/bluetooth/hci_qca.c > +++ b/drivers/bluetooth/hci_qca.c > @@ -1975,6 +1975,38 @@ static void qca_serdev_remove(struct serdev_device *serdev) > hci_uart_unregister_device(&qcadev->serdev_hu); > } > > +static void qca_serdev_shutdown(struct device *dev) > +{ > + int ret; > + int timeout = msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS); > + struct serdev_device *serdev = to_serdev_device(dev); > + struct qca_serdev *qcadev = serdev_device_get_drvdata(serdev); > + const u8 ibs_wake_cmd[] = { 0xFD }; > + const u8 edl_reset_soc_cmd[] = { 0x01, 0x00, 0xFC, 0x01, 0x05 }; struct hci_dev *hdev = container_of(dev, struct hci_dev, dev); > + > + if (qcadev->btsoc_type == QCA_QCA6390) { > + serdev_device_write_flush(serdev); > + ret = serdev_device_write_buf(serdev, > + ibs_wake_cmd, sizeof(ibs_wake_cmd)); > + if (ret < 0) { > + BT_ERR("QCA send IBS_WAKE_IND error: %d", ret); And then use bt_dev_err here. > + return; > + } > + serdev_device_wait_until_sent(serdev, timeout); > + usleep_range(8000, 10000); > + > + serdev_device_write_flush(serdev); > + ret = serdev_device_write_buf(serdev, > + edl_reset_soc_cmd, sizeof(edl_reset_soc_cmd)); > + if (ret < 0) { > + BT_ERR("QCA send EDL_RESET_REQ error: %d", ret); > + return; > + } > + serdev_device_wait_until_sent(serdev, timeout); > + usleep_range(8000, 10000); > + } > +} > + > static int __maybe_unused qca_suspend(struct device *dev) > { > struct hci_dev *hdev = container_of(dev, struct hci_dev, dev); > @@ -2100,6 +2132,7 @@ static struct serdev_device_driver qca_serdev_driver = { > .name = "hci_uart_qca", > .of_match_table = of_match_ptr(qca_bluetooth_of_match), > .acpi_match_table = ACPI_PTR(qca_bluetooth_acpi_match), > + .shutdown = qca_serdev_shutdown, > .pm = &qca_pm_ops, > }, > }; Regards Marcel