The btusb_rtl_cmd_timeout() function is used inside of an
ifdef, leading to a warning when this part is hidden
from the compiler:
drivers/bluetooth/btusb.c:530:13: error: unused function 'btusb_rtl_cmd_timeout' [-Werror,-Wunused-function]
Use an IS_ENABLED() check instead so the compiler can see
the code and then discard it silently.
Fixes: d7ef0d1e3968 ("Bluetooth: btusb: Use cmd_timeout to reset Realtek device")
Signed-off-by: Arnd Bergmann <arnd@xxxxxxxx>
---
drivers/bluetooth/btusb.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index a9c35ebb30f8..23e606aaaea4 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -3807,8 +3807,8 @@ static int btusb_probe(struct usb_interface *intf,
btusb_check_needs_reset_resume(intf);
}
-#ifdef CONFIG_BT_HCIBTUSB_RTL
- if (id->driver_info & BTUSB_REALTEK) {
+ if (IS_ENABLED(CONFIG_BT_HCIBTUSB_RTL) &&
+ (id->driver_info & BTUSB_REALTEK)) {
hdev->setup = btrtl_setup_realtek;
hdev->shutdown = btrtl_shutdown_realtek;
hdev->cmd_timeout = btusb_rtl_cmd_timeout;
@@ -3819,7 +3819,6 @@ static int btusb_probe(struct usb_interface *intf,
*/
set_bit(BTUSB_WAKEUP_DISABLE, &data->flags);
}
-#endif
if (id->driver_info & BTUSB_AMP) {
/* AMP controllers do not support SCO packets */
--
2.20.0
