Uploading the firmware needs quite a few seconds if done at 115200 kbps. So set
the operational frequency, usually 3 MHz, before uploading the firmware.
I have successfully tested this with a wl1837mod.
Signed-off-by: Philipp Puschmann <philipp.puschmann@xxxxxxxxx>
---
drivers/bluetooth/hci_ll.c | 39 ++++++++++++++++++++------------------
1 file changed, 21 insertions(+), 18 deletions(-)
diff --git a/drivers/bluetooth/hci_ll.c b/drivers/bluetooth/hci_ll.c
index c04f5f9e1ed0..cbd7bc539d5e 100644
--- a/drivers/bluetooth/hci_ll.c
+++ b/drivers/bluetooth/hci_ll.c
@@ -601,6 +601,13 @@ static int ll_setup(struct hci_uart *hu)
serdev_device_set_flow_control(serdev, true);
+ if (hu->oper_speed)
+ speed = hu->oper_speed;
+ else if (hu->proto->oper_speed)
+ speed = hu->proto->oper_speed;
+ else
+ speed = 0;
+
do {
/* Reset the Bluetooth device */
gpiod_set_value_cansleep(lldev->enable_gpio, 0);
@@ -612,6 +619,20 @@ static int ll_setup(struct hci_uart *hu)
return err;
}
+ if (speed) {
+ __le32 speed_le = cpu_to_le32(speed);
+ struct sk_buff *skb;
+
+ skb = __hci_cmd_sync(hu->hdev,
+ HCI_VS_UPDATE_UART_HCI_BAUDRATE,
+ sizeof(speed_le), &speed_le,
+ HCI_INIT_TIMEOUT);
+ if (!IS_ERR(skb)) {
+ kfree_skb(skb);
+ serdev_device_set_baudrate(serdev, speed);
+ }
+ }
+
err = download_firmware(lldev);
if (!err)
break;
@@ -636,25 +657,7 @@ static int ll_setup(struct hci_uart *hu)
}
/* Operational speed if any */
- if (hu->oper_speed)
- speed = hu->oper_speed;
- else if (hu->proto->oper_speed)
- speed = hu->proto->oper_speed;
- else
- speed = 0;
-
- if (speed) {
- __le32 speed_le = cpu_to_le32(speed);
- struct sk_buff *skb;
- skb = __hci_cmd_sync(hu->hdev, HCI_VS_UPDATE_UART_HCI_BAUDRATE,
- sizeof(speed_le), &speed_le,
- HCI_INIT_TIMEOUT);
- if (!IS_ERR(skb)) {
- kfree_skb(skb);
- serdev_device_set_baudrate(serdev, speed);
- }
- }
return 0;
}
--
2.20.1
