This adds serdev support to the Marvell hci uart driver. Only basic
serdev support, none of the fancier features like regulator or enable
GPIO support is added for now.
Signed-off-by: Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
---
.../bindings/net/marvell-bluetooth.txt | 25 +++++++
drivers/bluetooth/Kconfig | 1 +
drivers/bluetooth/hci_mrvl.c | 69 ++++++++++++++++++-
3 files changed, 94 insertions(+), 1 deletion(-)
create mode 100644 Documentation/devicetree/bindings/net/marvell-bluetooth.txt
diff --git a/Documentation/devicetree/bindings/net/marvell-bluetooth.txt b/Documentation/devicetree/bindings/net/marvell-bluetooth.txt
new file mode 100644
index 000000000000..0e2842296032
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/marvell-bluetooth.txt
@@ -0,0 +1,25 @@
+Marvell Bluetooth Chips
+-----------------------
+
+This documents the binding structure and common properties for serial
+attached Marvell Bluetooth devices. The following chips are included in
+this binding:
+
+* Marvell 88W8897 Bluetooth devices
+
+Required properties:
+ - compatible: should be:
+ "mrvl,88w8897"
+
+Optional properties:
+None so far
+
+Example:
+
+&serial0 {
+ compatible = "ns16550a";
+ ...
+ bluetooth {
+ compatible = "mrvl,88w8897";
+ };
+};
diff --git a/drivers/bluetooth/Kconfig b/drivers/bluetooth/Kconfig
index b9c34ff9a0d3..a3fafd781aa1 100644
--- a/drivers/bluetooth/Kconfig
+++ b/drivers/bluetooth/Kconfig
@@ -237,6 +237,7 @@ config BT_HCIUART_AG6XX
config BT_HCIUART_MRVL
bool "Marvell protocol support"
depends on BT_HCIUART
+ depends on BT_HCIUART_SERDEV
select BT_HCIUART_H4
help
Marvell is serial protocol for communication between Bluetooth
diff --git a/drivers/bluetooth/hci_mrvl.c b/drivers/bluetooth/hci_mrvl.c
index a0a74362455e..f98e5cc343b2 100644
--- a/drivers/bluetooth/hci_mrvl.c
+++ b/drivers/bluetooth/hci_mrvl.c
@@ -13,6 +13,8 @@
#include <linux/firmware.h>
#include <linux/module.h>
#include <linux/tty.h>
+#include <linux/of.h>
+#include <linux/serdev.h>
#include <net/bluetooth/bluetooth.h>
#include <net/bluetooth/hci_core.h>
@@ -40,6 +42,10 @@ struct mrvl_data {
u8 id, rev;
};
+struct mrvl_serdev {
+ struct hci_uart hu;
+};
+
struct hci_mrvl_pkt {
__le16 lhs;
__le16 rhs;
@@ -49,6 +55,7 @@ struct hci_mrvl_pkt {
static int mrvl_open(struct hci_uart *hu)
{
struct mrvl_data *mrvl;
+ int ret;
BT_DBG("hu %p", hu);
@@ -62,7 +69,18 @@ static int mrvl_open(struct hci_uart *hu)
set_bit(STATE_CHIP_VER_PENDING, &mrvl->flags);
hu->priv = mrvl;
+
+ if (hu->serdev) {
+ ret = serdev_device_open(hu->serdev);
+ if (ret)
+ goto err;
+ }
+
return 0;
+err:
+ kfree(mrvl);
+
+ return ret;
}
static int mrvl_close(struct hci_uart *hu)
@@ -71,6 +89,9 @@ static int mrvl_close(struct hci_uart *hu)
BT_DBG("hu %p", hu);
+ if (hu->serdev)
+ serdev_device_close(hu->serdev);
+
skb_queue_purge(&mrvl->txq);
skb_queue_purge(&mrvl->rawq);
kfree_skb(mrvl->rx_skb);
@@ -342,7 +363,11 @@ static int mrvl_setup(struct hci_uart *hu)
/* Let the final ack go out before switching the baudrate */
hci_uart_wait_until_sent(hu);
- hci_uart_set_baudrate(hu, 3000000);
+ if (hu->serdev)
+ serdev_device_set_baudrate(hu->serdev, 3000000);
+ else
+ hci_uart_set_baudrate(hu, 3000000);
+
hci_uart_set_flow_control(hu, false);
err = mrvl_load_firmware(hu->hdev, "mrvl/uart8897_bt.bin");
@@ -365,12 +390,54 @@ static const struct hci_uart_proto mrvl_proto = {
.dequeue = mrvl_dequeue,
};
+static int mrvl_serdev_probe(struct serdev_device *serdev)
+{
+ struct mrvl_serdev *mrvldev;
+
+ mrvldev = devm_kzalloc(&serdev->dev, sizeof(*mrvldev), GFP_KERNEL);
+ if (!mrvldev)
+ return -ENOMEM;
+
+ mrvldev->hu.serdev = serdev;
+ serdev_device_set_drvdata(serdev, mrvldev);
+
+ return hci_uart_register_device(&mrvldev->hu, &mrvl_proto);
+}
+
+static void mrvl_serdev_remove(struct serdev_device *serdev)
+{
+ struct mrvl_serdev *mrvldev = serdev_device_get_drvdata(serdev);
+
+ hci_uart_unregister_device(&mrvldev->hu);
+}
+
+#ifdef CONFIG_OF
+static const struct of_device_id mrvl_bluetooth_of_match[] = {
+ { .compatible = "mrvl,88w8897" },
+ { },
+};
+MODULE_DEVICE_TABLE(of, mrvl_bluetooth_of_match);
+#endif
+
+static struct serdev_device_driver mrvl_serdev_driver = {
+ .probe = mrvl_serdev_probe,
+ .remove = mrvl_serdev_remove,
+ .driver = {
+ .name = "hci_uart_mrvl",
+ .of_match_table = of_match_ptr(mrvl_bluetooth_of_match),
+ },
+};
+
int __init mrvl_init(void)
{
+ serdev_device_driver_register(&mrvl_serdev_driver);
+
return hci_uart_register_proto(&mrvl_proto);
}
int __exit mrvl_deinit(void)
{
+ serdev_device_driver_unregister(&mrvl_serdev_driver);
+
return hci_uart_unregister_proto(&mrvl_proto);
}
--
2.20.1
