Hello, I am currently using blueZ5.43 on my device. My device is currently running on linux-3.10 kernel. We are currently using Both BT classic and ble. We are presenlty using SPP profile by running the rfcomm utilty. We are playing the slave role in SPP and listening to any SPP incoming connection. Similarly we have written some custom GATT service, which we added to the list of core gatt_services which are registered when the bluetoothd comes up. For other devices to connect to our SPP slave we are doing "hciconfig hci0 piscan". Also for other devices to connect to our GATT service we are doing BLE advertising. In the advertising data we are setting the "Complete Local Name" as "XXXXXXXXX_XXXXXX"(just putting wild characters instead of actual name we used in our case). We set the device name as "XXXXXXXXX_XXXXXX_BT" in /etc/bluetooth/bluetooth.conf and the bluetoothd sets the device name the same when it comes up. We are running the bluetoothd with --compat option so that the sdptool adds the SPP profile. With this setup when we are discovering the device from any other device (Like windows 10 machine or from Android device). We are seeing sometimes the device shows up with "XXXXXXXXX_XXXXXX_BT" and sometimes the device shows up with "XXXXXXXXX_XXXXXX" and this continues to happen with only one visible at a time. if we try to connect and pair with "XXXXXXXXX_XXXXXX" it sends a GATT Connect request and subsequently pairs and does GATT discovery but doesn't discover SPP. if we try to connect and pair with "XXXXXXXXX_XXXXXX_BT" it sends a accept connection request, and subsequenlty pairs and does SDP discovery and the SPP shows up on a particular BT serial port Based on the above points following are my question: 1)Why scanning of the device is showing separate entries for BLE and BT classic. 2)Is there a way to make our device visible to outside world, where it will only appear once in the scanned list of the other devices and discover both GATT as well as SPP profile? Any suggestions would be helpful. Thanks.
