Hello,
I have a system that comes with BlueZ 5.43 installed on a single board
computer (SBC). I have downloaded, built and installed various newer
versions of BlueZ but I am having problems getting them working
correctly.
I have a peripheral (very similar to the gatt server example in the
test directory) with one characteristic. My example was working before
upgrading. However after upgrading, when I turn on notification for
the characteristic it is not showing on the phone.
I do see the notification turn up in dbus-monitor but not in btmon.
signal time=1551910979.743011 sender=:1.38 -> destination=(null
destination) serial=339 path=/ukBaz/bluezero/service0001/char0001;
interface=org.freedesktop.DBus.Properties; member=PropertiesChanged
string "org.bluez.GattCharacteristic1"
array [
dict entry(
string "Value"
variant array of bytes [
78 14
]
)
]
array [
]
I have tried going back to version 5.43 again but now that is not
working either.
The configure I ran was:
./configure --prefix=/usr \
--mandir=/usr/share/man \
--sysconfdir=/etc \
--localstatedir=/var \
--enable-experimental \
--enable-maintainer-mode
To get configure to work without error I needed to install the following:
sudo apt install glib2.
sudo apt install libdbus-1-dev libudev-dev libical-dev libreadline-dev
I have tried various variations on this and done a lot of searching
but don't seem to find an answer.
Is anyone else seeing this issue?
Anyone have any suggestions as what I could try?
Thanks in advance,
Barry
