Hi Marcel, On Wed, Feb 27, 2019 at 08:48:31AM +0100, Marcel Holtmann wrote: > Hi Matthias, > > > The current 300ms delay after a baudrate change is extremely long. > > For WCM3990 it is sufficient to wait 10ms after the baudrate change > > request has been sent over the wire. > > > > Also use msleep() instead of a set_current_state() / schedule_timeout() > > combo. > > > > Matthias Kaehlcke (2): > > hci_qca: Use msleep() instead of open coding it > > hci_qca: Reduce delay after sending baudrate request for WCN3990 > > > > drivers/bluetooth/hci_qca.c | 30 +++++++++++++++++++++--------- > > 1 file changed, 21 insertions(+), 9 deletions(-) > > patch 1/2 has been applied to bluetooth-next tree. Thanks! > The patch 2/2 fails to apply. Right, the series "Bluetooth: hci_qca: Add delay after power-off pulse" that was just applied touches the same code. I'll send a rebased version soon. Cheers Matthias