[PATCH v2 0/3] Bluetooth: hci_qca: Add delay after power-off pulse

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Initialization of the QCA WCN3990 often fails at boot time:

 [   15.205224] Bluetooth: hci0: setting up wcn3990
 [   17.341062] Bluetooth: hci0: command 0xfc00 tx timeout
 [   22.101453] ERROR: Bluetooth initialization failed
 [   25.337740] Bluetooth: hci0: Reading QCA version information failed (-110)

A short delay after sending a power-off pulse (which is done immediately
before sending a power-on pulse) fixes this.

Also move the delays to qca_send_power_pulse(), since they are directly
related with sending the pulses. Change the interface of
qca_send_power_pulse() to receive a boolean instead of a power pulse
command, this improves readability of the function with the delays
added.

Matthias Kaehlcke (3):
  Bluetooth: hci_qca: Pass boolean 'on/off' to qca_send_power_pulse()
  Bluetooth: hci_qca: Move boot delay to qca_send_power_pulse()
  Bluetooth: hci_qca: Add delay after power-off pulse

 drivers/bluetooth/hci_qca.c | 21 +++++++++++----------
 1 file changed, 11 insertions(+), 10 deletions(-)

-- 
2.21.0.rc2.261.ga7da99ff1b-goog




[Index of Archives]     [Bluez Devel]     [Linux Wireless Networking]     [Linux Wireless Personal Area Networking]     [Linux ATH6KL]     [Linux USB Devel]     [Linux Media Drivers]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Big List of Linux Books]

  Powered by Linux