Re: [PATCH v5 2/5] Bluetooth: hci_qca: Deassert RTS while baudrate change command

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Johan,

On 2019-01-10 20:09, Johan Hovold wrote:
On Thu, Jan 10, 2019 at 08:04:12PM +0530, Balakrishna Godavarthi wrote:
Hi Johan,

On 2019-01-09 20:22, Johan Hovold wrote:
> On Thu, Dec 20, 2018 at 08:16:36PM +0530, Balakrishna Godavarthi wrote:
>> This patch will help to stop frame reassembly errors while changing
>> the baudrate. This is because host send a change baudrate request
>> command to the chip with 115200 bps, Whereas chip will change their
>> UART clocks to the enable for new baudrate and sends the response
>> for the change request command with newer baudrate, On host side
>> we are still operating in 115200 bps which results of reading garbage
>> data. Here we are pulling RTS line, so that chip we will wait to send
>> data
>> to host until host change its baudrate.

>> +		/* Deassert RTS while changing the baudrate of chip and host.
>> +		 * This will prevent chip from transmitting its response with
>> +		 * the new baudrate while the host port is still operating at
>> +		 * the old speed.
>> +		 */
>> +		qcadev = serdev_device_get_drvdata(hu->serdev);
>> +		if (qcadev->btsoc_type == QCA_WCN3990)
>> +			serdev_device_set_rts(hu->serdev, false);
>> +
>
> This may not do what you want unless you also disable hardware flow
> control.

Here my requirement here is to block the chip to send its data before
HOST changes it is baudrate. So if i disable flow control lines of
HOST which will be in low state.  so that the chip will send it data
before HOST change the baudrate of HOST. which results in frame
reassembly error.

Not sure I understand what you're trying to say above. My point is that
you cannot reliable control RTS when you have automatic flow control
enabled (i.e. it is managed by hardware and it's state reflects whether
there's room in the UART receive FIFO).

Johan

[Bala]: Yes i got your point, but our driver will not support automatic flow control (based on the FIFO status) unless we explicitly enabled via software. i.e. if we enable the flow, hardware will look for it.
        else it will not looks for CTS or RTS Line.

--
Regards
Balakrishna.



[Index of Archives]     [Bluez Devel]     [Linux Wireless Networking]     [Linux Wireless Personal Area Networking]     [Linux ATH6KL]     [Linux USB Devel]     [Linux Media Drivers]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Big List of Linux Books]

  Powered by Linux