This patch is to balance the condition scope between hci_get_cmd_complete and
hci_event_packet about orig_skb as follows:
if (req_complete_skb || event == HCI_EV_CMD_STATUS ||
event == HCI_EV_CMD_COMPLETE)
orig_skb = skb_clone(skb, GFP_KERNEL);
And hci_get_cmd_complete will bt_dev_err out when HCI_EV_CMD_STATUS, so a lot
of asymmetric conditions are triggered. Since both of them are the entry into
hci_get_cmd_complete, we'd better get STATUS into judge the false out there.
Signed-off-by: Zumeng Chen <zumeng.chen@xxxxxxxxx>
---
Hi expert,
This issue existed whether or not T_DBG had been changed into bt_dev_err, which
just shows the issue explicitly. I noticed actually that opcode doesn't match
ev->opcode either at the same time. And there might be some logic issue about
HCI_EV_CMD_COMPLETE between protocol and drivers. I'm not familar with the whole
bluetooth protocol, and not gonna to dig more, so all yours guys~
Cheers,
Zumeng
net/bluetooth/hci_event.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/net/bluetooth/hci_event.c b/net/bluetooth/hci_event.c
index 235b5aa..d848663 100644
--- a/net/bluetooth/hci_event.c
+++ b/net/bluetooth/hci_event.c
@@ -5217,7 +5217,8 @@ static bool hci_get_cmd_complete(struct hci_dev *hdev, u16 opcode,
return true;
}
- if (hdr->evt != HCI_EV_CMD_COMPLETE) {
+ if (!((hdr->evt == HCI_EV_CMD_COMPLETE) ||
+ (hdr->evt == HCI_EV_CMD_STATUS))) {
bt_dev_err(hdev, "last event is not cmd complete (0x%2.2x)",
hdr->evt);
return false;
--
2.7.4
