Hi Marcel,
On 17/08/2017 21:48, Marcel Holtmann wrote:
Hi Loic,
Add basic support for Broadcom serial slave devices.
Probe the serial device, retrieve its maximum speed and
register a new hci uart device.
Tested/compatible with bcm43438 (RPi3).
Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxx>
---
v2: dt-bindings as separate patch
rebase on upcoming pi3 dts changes
v3: changes in bcm serdev drivers:
name refactoring and additional comments
Add generic host_set_baudrate method
Use agnostic device_property_read
v4: changes in doc and dts:
Add additional params to broadcom bt dt-bindings
Set the max baudrate to 2000000 instead of 921600
use chosen/stdout-path instead of console=
remove useless earlyprintk
same changes in bcm283x.dtsi
drivers/bluetooth/hci_bcm.c | 85 +++++++++++++++++++++++++++++++++++++++++++--
1 file changed, 83 insertions(+), 2 deletions(-)
I decided to amend your patch with the required Kconfig addition and then just applied 1/4 and 4/4 to bluetooth-next tree.
For 2/4 and 3/4, I think they should go through the DT tree since they depend on other changes. I can not apply since none of these changes are in any of my parent trees.
Thanks for the amend.
Indeed 2 and 3 depend on the following DT tree changes (Stefan):
[PATCH v2] ARM: dts: bcm283x: Move the BCM2837 DT contents from arm64 to
arm.
[PATCH V2 0/3] ARM: bcm283x: Raspberry Pi Zero W support
Regards,
Loic
--
To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
