Apply DDC parameters once controller is in operational mode.
Signed-off-by: Loic Poulain <loic.poulain@xxxxxxxxx>
---
v2: use fwname instead of additional dedicated buffer
drivers/bluetooth/hci_intel.c | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/drivers/bluetooth/hci_intel.c b/drivers/bluetooth/hci_intel.c
index b4dc3c5..556d2e6 100644
--- a/drivers/bluetooth/hci_intel.c
+++ b/drivers/bluetooth/hci_intel.c
@@ -735,6 +735,10 @@ static int intel_setup(struct hci_uart *hu)
bt_dev_info(hdev, "Found device firmware: %s", fwname);
+ /* Save the DDC file name for later */
+ snprintf(fwname, sizeof(fwname), "intel/ibt-11-%u.ddc",
+ le16_to_cpu(params->dev_revid));
+
kfree_skb(skb);
if (fw->size < 644) {
@@ -927,6 +931,9 @@ done:
set_bit(STATE_LPM_ENABLED, &intel->flags);
no_lpm:
+ /* Ignore ddc error, device can work without DDC parameters */
+ btintel_load_ddc_config(hdev, fwname);
+
skb = __hci_cmd_sync(hdev, HCI_OP_RESET, 0, NULL, HCI_CMD_TIMEOUT);
if (IS_ERR(skb))
return PTR_ERR(skb);
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
