Hi Marcel,
this is a really bad behavior from our firmware then. We would actually like to get the cmd status or cmd complete on the current baud rate and once that has been confirmed, we switch to the new baud rate. I remember that there are actually two different baud rate change commands for the Intel controllers. Are you using the right one?
I don't know about a second vendor command to change the baudrate.
I use the same one used in hciattach_intel where the behavior seems
identical.
Regards,
Loic
--
Intel Open Source Technology Center
http://oss.intel.com/
--
To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
