On 06/06/2015 01:31 PM, Marcel Holtmann wrote:
Hi Larry,
since the interrupt endpoint is only used for HCI events, you do not even need connections. This could be anything simple like HCI command complete event.
Now I wonder if this is something odd where the HCI event fits completely into a single interrupt URB or something special like that. If you get get the content of that URB, then I might be able to track this down. Or do you have a chance to run btmon and correlate the timestamps.
Synchronizing the timing between kmemleak and btmon is a little difficult as the
former reports time only in jiffies and seconds before present. I will keep
looking, but I think the leaked allocation happened at roughly 16:17:52. The
only things that btmon logged are
> HCI Event: Number of Completed Packets (0x13) plen 5
[hci0] 8
Num handles: 1
Handle: 256
Count: 1
> ACL Data RX: Handle 256 flags 0x02 dlen 12
[hci0] 16:18:49.598733
L2CAP: Disconnection Response (0x07) ident 4 len 4
Destination CID: 65
Source CID: 64
< HCI Command: Read Clock Offset (0x01|0x001f) plen 2
[hci0] 16:18:51.601920
Handle: 256
> HCI Event: Command Status (0x0f) plen 4
[hci0] 16:18:51.602808
Read Clock Offset (0x01|0x001f) ncmd 1
Status: Success (0x00)
< HCI Command: Disconnect (0x01|0x0006) plen 3
[hci0] 16:18:51.603069
Handle: 256
Reason: Remote User Terminated Connection (0x13)
> HCI Event: Command Status (0x0f) plen 4
[hci0] 16:18:51.603750
Disconnect (0x01|0x0006) ncmd 1
Status: Success (0x00)
> HCI Event: Read Clock Offset Complete (0x1c) plen 5
[hci0] 16:18:51.606847
Status: Success (0x00)
Handle: 256
Clock offset: 0x4568
> HCI Event: Disconnect Complete (0x05) plen 4
[hci0] 16:18:51.687885
Status: Success (0x00)
Handle: 256
Reason: Connection Terminated By Local Host (0x16)
@ Device Disconnected: 00:26:5F:D4:27:72 (0) reason 2
< HCI Command: Write Scan Enable (0x03|0x001a) plen 1
[hci0] 16:18:51.701737
Scan enable: Page Scan (0x02)
> HCI Event: Command Complete (0x0e) plen 4
[hci0] 16:18:51.702749
Write Scan Enable (0x03|0x001a) ncmd 2
Status: Success (0x00)
@ Device Removed: 00:26:5F:D4:27:72 (0)
< HCI Command: Write Scan Enable (0x03|0x001a) plen 1
[hci0] 16:19:04.771489
Scan enable: No Scans (0x00)
--
To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
