From: Luiz Augusto von Dentz <luiz.von.dentz@xxxxxxxxx> This adds Send HCI command and wait for event Command initial documentation. --- doc/mgmt-api.txt | 30 ++++++++++++++++++++++++++++++ 1 file changed, 30 insertions(+) diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt index 59e61d361dc2..d37eae402861 100644 --- a/doc/mgmt-api.txt +++ b/doc/mgmt-api.txt @@ -3991,6 +3991,36 @@ Cancel Transmit Mesh Packet Command Possible errors: Failed Invalid Parameters +Send HCI command and wait for event Command +=========================================== + + Command Code: 0x005B + Controller Index: <controller id> + Command Parameters: Opcode (2 Octets) + Event (1 Octet) + Timeout (1 Octet) + Parameter Length (2 Octets) + Parameter (variable) + Return Parameters: Response (1-variable Octets) + + This command may be used to send a HCI command and wait for an + (optional) event. + + The HCI command is specified by the Opcode, any arbitrary is supported + including vendor commands, but contrary to the like of + Raw/User channel it is run as an HCI command send by the kernel + since it uses its command synchronization thus it is possible to wait + for a specific event as a response. + + Setting event to 0x00 will cause the command to wait for either + HCI Command Status or HCI Command Complete. + + Timeout is specified in seconds, setting it to 0 will cause the + default timeout to be used. + + Possible errors: Failed + Invalid Parameters + Command Complete Event ====================== -- 2.47.0
