For the WCN6750/WCN6855/WCN7850, the vendor command for a baudrate
change is not sent as synchronous HCI command, controller sends the
corresponding vendor event with the new baudrate. It needs to be
dropped, otherwise it may be misinterpreted as response to a later
command.
According to
80-WL520-14_REV_F_Bluetooth_HCI_Vendor_Specific_Commands_Application_Note.pdf
event for set baudrate HCI command is sent with event code
HCI_EV_CMD_COMPLETE(0x0e), add related handle in qca_recv_event when
sending set baudrate HCI command.
Signed-off-by: Cheng Jiang <quic_chejiang@xxxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 15 ++++++++++++++-
1 file changed, 14 insertions(+), 1 deletion(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index ca6466676902..8dacf6dcf248 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1206,7 +1206,14 @@ static int qca_recv_event(struct hci_dev *hdev, struct sk_buff *skb)
* vendor command).
*/
- if (hdr->evt == HCI_EV_VENDOR)
+ /* For the WCN6750/WCN6855/WCN7850, like the WCN3990, the
+ * vendor command for a baudrate change command isn't sent as
+ * synchronous HCI command, the controller sends the corresponding
+ * command complete event with the new baudrate. The event is
+ * received and properly decoded after changing the baudrate of
+ * the host port. It needs to be dropped.
+ */
+ if (hdr->evt == HCI_EV_VENDOR || hdr->evt == HCI_EV_CMD_COMPLETE)
complete(&qca->drop_ev_comp);
kfree_skb(skb);
@@ -1497,6 +1504,9 @@ static int qca_set_speed(struct hci_uart *hu, enum qca_speed_type speed_type)
switch (soc_type) {
case QCA_WCN3990:
+ case QCA_WCN6750:
+ case QCA_WCN6855:
+ case QCA_WCN7850:
reinit_completion(&qca->drop_ev_comp);
set_bit(QCA_DROP_VENDOR_EVENT, &qca->flags);
break;
@@ -1531,6 +1541,9 @@ static int qca_set_speed(struct hci_uart *hu, enum qca_speed_type speed_type)
switch (soc_type) {
case QCA_WCN3990:
+ case QCA_WCN6750:
+ case QCA_WCN6855:
+ case QCA_WCN7850:
/* Wait for the controller to send the vendor event
* for the baudrate change command.
*/
--
2.25.1
