From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
In preparation for using the power sequencing subsystem on sm8650 boards
and X13s laptop let's make pwrseq the default for wcn7850 and wcn6855.
Both these models require an enable GPIO so we can safely assume that if
the property is not there, then we should try to get the power
sequencer. Due to how the pwrseq lookup works - checking the provider at
run-time - we cannot really do it the other way around as we'd get stuck
forever on -EPROBE_DEFER.
If the relevant OF node does have the 'enable-gpios' property, we
fallback to the existing code for backward compatibility with older DTs.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 19 +++++++++++++++++--
1 file changed, 17 insertions(+), 2 deletions(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index f2dd37d01189..bcc6483074ff 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -2354,13 +2354,28 @@ static int qca_serdev_probe(struct serdev_device *serdev)
}
switch (qcadev->btsoc_type) {
+ case QCA_WCN6855:
+ case QCA_WCN7850:
+ if (!device_property_present(&serdev->dev, "enable-gpios")) {
+ /*
+ * Backward compatibility with old DT sources. If the
+ * node doesn't have the 'enable-gpios' property then
+ * let's use the power sequencer. Otherwise, let's
+ * drive everything outselves.
+ */
+ qcadev->bt_power->pwrseq = devm_pwrseq_get(&serdev->dev,
+ "bluetooth");
+ if (IS_ERR(qcadev->bt_power->pwrseq))
+ return PTR_ERR(qcadev->bt_power->pwrseq);
+
+ break;
+ }
+ fallthrough;
case QCA_WCN3988:
case QCA_WCN3990:
case QCA_WCN3991:
case QCA_WCN3998:
case QCA_WCN6750:
- case QCA_WCN6855:
- case QCA_WCN7850:
qcadev->bt_power->dev = &serdev->dev;
err = qca_init_regulators(qcadev->bt_power, data->vregs,
data->num_vregs);
--
2.43.0
