From: Hector Martin <marcan@xxxxxxxxx>
This new variant needs a different core2_window1 and always uses
beamforming.
The BAR2 also has an offset (RAM start, presumably), so add that.
Signed-off-by: Hector Martin <marcan@xxxxxxxxx>
Reviewed-by: Sven Peter <sven@xxxxxxxxxxxxx>
[sven: rebased, updated some comments, mentioned 4388 in Kconfig]
Signed-off-by: Sven Peter <sven@xxxxxxxxxxxxx>
---
Hi,
This is just a single commit mostly written by Hector that adds support
for BCM4388 chips. I've just rebased this to the current bluetooth-next
since it also needs 9dc8ac15ca5 and adjusted some comments.
Best,
Sven
---
drivers/bluetooth/Kconfig | 6 ++--
drivers/bluetooth/hci_bcm4377.c | 61 +++++++++++++++++++++++++++++++----------
2 files changed, 50 insertions(+), 17 deletions(-)
diff --git a/drivers/bluetooth/Kconfig b/drivers/bluetooth/Kconfig
index 0b5f218ac505..87484f5de8e3 100644
--- a/drivers/bluetooth/Kconfig
+++ b/drivers/bluetooth/Kconfig
@@ -287,12 +287,12 @@ config BT_HCIBCM203X
config BT_HCIBCM4377
- tristate "HCI BCM4377/4378/4387 PCIe driver"
+ tristate "HCI BCM4377/4378/4387/4388 PCIe driver"
depends on PCI
select FW_LOADER
help
- Support for Broadcom BCM4377/4378/4387 Bluetooth chipsets attached via
- PCIe. These are usually found in Apple machines.
+ Support for Broadcom BCM4377/4378/4387/4388 Bluetooth chipsets
+ attached via PCIe. These are usually found in Apple machines.
Say Y here to compile support for HCI BCM4377 family devices into the
kernel or say M to compile it as module (hci_bcm4377).
diff --git a/drivers/bluetooth/hci_bcm4377.c b/drivers/bluetooth/hci_bcm4377.c
index e6644cb0163c..77a5454a8721 100644
--- a/drivers/bluetooth/hci_bcm4377.c
+++ b/drivers/bluetooth/hci_bcm4377.c
@@ -1,6 +1,6 @@
// SPDX-License-Identifier: GPL-2.0-only OR MIT
/*
- * Bluetooth HCI driver for Broadcom 4377/4378/4387 devices attached via PCIe
+ * Bluetooth HCI driver for Broadcom 4377/4378/4387/4388 devices attached via PCIe
*
* Copyright (C) The Asahi Linux Contributors
*/
@@ -26,11 +26,13 @@ enum bcm4377_chip {
BCM4377 = 0,
BCM4378,
BCM4387,
+ BCM4388,
};
#define BCM4377_DEVICE_ID 0x5fa0
#define BCM4378_DEVICE_ID 0x5f69
#define BCM4387_DEVICE_ID 0x5f71
+#define BCM4388_DEVICE_ID 0x5f72
#define BCM4377_TIMEOUT msecs_to_jiffies(1000)
#define BCM4377_BOOT_TIMEOUT msecs_to_jiffies(5000)
@@ -488,6 +490,7 @@ struct bcm4377_data;
* second window in BAR0
* has_bar0_core2_window2: Set to true if this chip requires the second core's
* second window to be configured
+ * bar2_offset: Offset to the start of the variables in BAR2
* clear_pciecfg_subsystem_ctrl_bit19: Set to true if bit 19 in the
* vendor-specific subsystem control
* register has to be cleared
@@ -511,6 +514,7 @@ struct bcm4377_hw {
u32 bar0_window1;
u32 bar0_window2;
u32 bar0_core2_window2;
+ u32 bar2_offset;
unsigned long has_bar0_core2_window2 : 1;
unsigned long clear_pciecfg_subsystem_ctrl_bit19 : 1;
@@ -836,8 +840,8 @@ static irqreturn_t bcm4377_irq(int irq, void *data)
struct bcm4377_data *bcm4377 = data;
u32 bootstage, rti_status;
- bootstage = ioread32(bcm4377->bar2 + BCM4377_BAR2_BOOTSTAGE);
- rti_status = ioread32(bcm4377->bar2 + BCM4377_BAR2_RTI_STATUS);
+ bootstage = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_BOOTSTAGE);
+ rti_status = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_STATUS);
if (bootstage != bcm4377->bootstage ||
rti_status != bcm4377->rti_status) {
@@ -1197,6 +1201,14 @@ static int bcm4387_send_calibration(struct bcm4377_data *bcm4377)
bcm4377->taurus_cal_size);
}
+static int bcm4388_send_calibration(struct bcm4377_data *bcm4377)
+{
+ /* BCM4388 always uses beamforming */
+ return __bcm4378_send_calibration(
+ bcm4377, bcm4377->taurus_beamforming_cal_blob,
+ bcm4377->taurus_beamforming_cal_size);
+}
+
static const struct firmware *bcm4377_request_blob(struct bcm4377_data *bcm4377,
const char *suffix)
{
@@ -1820,8 +1832,8 @@ static int bcm4377_boot(struct bcm4377_data *bcm4377)
int ret = 0;
u32 bootstage, rti_status;
- bootstage = ioread32(bcm4377->bar2 + BCM4377_BAR2_BOOTSTAGE);
- rti_status = ioread32(bcm4377->bar2 + BCM4377_BAR2_RTI_STATUS);
+ bootstage = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_BOOTSTAGE);
+ rti_status = ioread32(bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_STATUS);
if (bootstage != 0) {
dev_err(&bcm4377->pdev->dev, "bootstage is %d and not 0\n",
@@ -1855,9 +1867,12 @@ static int bcm4377_boot(struct bcm4377_data *bcm4377)
iowrite32(BCM4377_DMA_MASK,
bcm4377->bar0 + BCM4377_BAR0_HOST_WINDOW_SIZE);
- iowrite32(lower_32_bits(fw_dma), bcm4377->bar2 + BCM4377_BAR2_FW_LO);
- iowrite32(upper_32_bits(fw_dma), bcm4377->bar2 + BCM4377_BAR2_FW_HI);
- iowrite32(fw->size, bcm4377->bar2 + BCM4377_BAR2_FW_SIZE);
+ iowrite32(lower_32_bits(fw_dma),
+ bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_FW_LO);
+ iowrite32(upper_32_bits(fw_dma),
+ bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_FW_HI);
+ iowrite32(fw->size,
+ bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_FW_SIZE);
iowrite32(0, bcm4377->bar0 + BCM4377_BAR0_FW_DOORBELL);
dev_dbg(&bcm4377->pdev->dev, "waiting for firmware to boot\n");
@@ -1914,16 +1929,16 @@ static int bcm4377_setup_rti(struct bcm4377_data *bcm4377)
dev_dbg(&bcm4377->pdev->dev, "RTI is in state 1\n");
/* allow access to the entire IOVA space again */
- iowrite32(0, bcm4377->bar2 + BCM4377_BAR2_RTI_WINDOW_LO);
- iowrite32(0, bcm4377->bar2 + BCM4377_BAR2_RTI_WINDOW_HI);
+ iowrite32(0, bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_WINDOW_LO);
+ iowrite32(0, bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_WINDOW_HI);
iowrite32(BCM4377_DMA_MASK,
- bcm4377->bar2 + BCM4377_BAR2_RTI_WINDOW_SIZE);
+ bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_RTI_WINDOW_SIZE);
/* setup "Converged IPC" context */
iowrite32(lower_32_bits(bcm4377->ctx_dma),
- bcm4377->bar2 + BCM4377_BAR2_CONTEXT_ADDR_LO);
+ bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_CONTEXT_ADDR_LO);
iowrite32(upper_32_bits(bcm4377->ctx_dma),
- bcm4377->bar2 + BCM4377_BAR2_CONTEXT_ADDR_HI);
+ bcm4377->bar2 + bcm4377->hw->bar2_offset + BCM4377_BAR2_CONTEXT_ADDR_HI);
iowrite32(2, bcm4377->bar0 + BCM4377_BAR0_RTI_CONTROL);
ret = wait_for_completion_interruptible_timeout(&bcm4377->event,
@@ -2489,6 +2504,21 @@ static const struct bcm4377_hw bcm4377_hw_variants[] = {
.send_calibration = bcm4387_send_calibration,
.send_ptb = bcm4378_send_ptb,
},
+
+ [BCM4388] = {
+ .id = 0x4388,
+ .otp_offset = 0x415c,
+ .bar2_offset = 0x200000,
+ .bar0_window1 = 0x18002000,
+ .bar0_window2 = 0x18109000,
+ .bar0_core2_window2 = 0x18106000,
+ .has_bar0_core2_window2 = true,
+ .broken_mws_transport_config = true,
+ .broken_le_coded = true,
+ .broken_le_ext_adv_report_phy = true,
+ .send_calibration = bcm4388_send_calibration,
+ .send_ptb = bcm4378_send_ptb,
+ },
};
#define BCM4377_DEVID_ENTRY(id) \
@@ -2502,6 +2532,7 @@ static const struct pci_device_id bcm4377_devid_table[] = {
BCM4377_DEVID_ENTRY(4377),
BCM4377_DEVID_ENTRY(4378),
BCM4377_DEVID_ENTRY(4387),
+ BCM4377_DEVID_ENTRY(4388),
{},
};
MODULE_DEVICE_TABLE(pci, bcm4377_devid_table);
@@ -2516,7 +2547,7 @@ static struct pci_driver bcm4377_pci_driver = {
module_pci_driver(bcm4377_pci_driver);
MODULE_AUTHOR("Sven Peter <sven@xxxxxxxxxxxxx>");
-MODULE_DESCRIPTION("Bluetooth support for Broadcom 4377/4378/4387 devices");
+MODULE_DESCRIPTION("Bluetooth support for Broadcom 4377/4378/4387/4388 devices");
MODULE_LICENSE("Dual MIT/GPL");
MODULE_FIRMWARE("brcm/brcmbt4377*.bin");
MODULE_FIRMWARE("brcm/brcmbt4377*.ptb");
@@ -2524,3 +2555,5 @@ MODULE_FIRMWARE("brcm/brcmbt4378*.bin");
MODULE_FIRMWARE("brcm/brcmbt4378*.ptb");
MODULE_FIRMWARE("brcm/brcmbt4387*.bin");
MODULE_FIRMWARE("brcm/brcmbt4387*.ptb");
+MODULE_FIRMWARE("brcm/brcmbt4388*.bin");
+MODULE_FIRMWARE("brcm/brcmbt4388*.ptb");
---
base-commit: 3c376f35eb13a144d5039d911b35110c2beef815
change-id: 20240602-btbcm4388-431aed90d763
Best regards,
--
Sven Peter <sven@xxxxxxxxxxxxx>
