From: Zijun Hu <zijuhu@xxxxxxxxxxxxxxxx>
Commit 272970be3dab ("Bluetooth: hci_qca: Fix driver shutdown on closed
serdev") will cause below regression issue:
BT can't be enabled after below steps:
cold boot -> enable BT -> disable BT -> warm reboot -> BT enable failure
if property enable-gpios is not configured within DT|ACPI for QCA_QCA6390.
The commit is to fix a use-after-free issue within qca_serdev_shutdown()
during reboot, but also introduces this new issue regarding above steps
since the VSC is not sent to reset controller during warm reboot.
Fixed by sending the VSC to reset controller within qca_serdev_shutdown()
once BT was ever enabled, and the use-after-free issue is also be fixed
by this change since serdev is still opened when send to serdev.
Fixes: 272970be3dab ("Bluetooth: hci_qca: Fix driver shutdown on closed serdev")
Reported-by: Wren Turkal <wt@xxxxxxxxxxxxxxxx>
Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218726
Signed-off-by: Zijun Hu <zijuhu@xxxxxxxxxxxxxxxx>
Tested-by: Wren Turkal <wt@xxxxxxxxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 4079254fb1c8..fc027da98297 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -2439,13 +2439,12 @@ static void qca_serdev_shutdown(struct device *dev)
struct qca_serdev *qcadev = serdev_device_get_drvdata(serdev);
struct hci_uart *hu = &qcadev->serdev_hu;
struct hci_dev *hdev = hu->hdev;
- struct qca_data *qca = hu->priv;
const u8 ibs_wake_cmd[] = { 0xFD };
const u8 edl_reset_soc_cmd[] = { 0x01, 0x00, 0xFC, 0x01, 0x05 };
if (qcadev->btsoc_type == QCA_QCA6390) {
- if (test_bit(QCA_BT_OFF, &qca->flags) ||
- !test_bit(HCI_RUNNING, &hdev->flags))
+ if (test_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks) ||
+ hci_dev_test_flag(hdev, HCI_SETUP))
return;
serdev_device_write_flush(serdev);
--
2.7.4
