For QCA2066 HFP offload, HCI_Configure_Data_Path is not required since
present HCI_Enhanced_Setup_Synchronous_Connection is enough to configure
non-HCI data transport path when set both Input_Data_Path and
Output_Data_Path parameters as 0x01, as is implemented by this change.
Signed-off-by: Zijun Hu <quic_zijuhu@xxxxxxxxxxx>
---
drivers/bluetooth/hci_qca.c | 22 ++++++++++++++++++++++
1 file changed, 22 insertions(+)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 35f74f209d1f..94b8c406f0c0 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1815,6 +1815,24 @@ static void hci_coredump_qca(struct hci_dev *hdev)
kfree_skb(skb);
}
+static int qca_get_data_path_id(struct hci_dev *hdev, __u8 *data_path_id)
+{
+ /* QCA uses 1 as non-HCI data path id for HFP */
+ *data_path_id = 1;
+ return 0;
+}
+
+static int qca_configure_hfp_offload(struct hci_dev *hdev)
+{
+ bt_dev_info(hdev, "HFP non-HCI data transport is supported");
+ hdev->get_data_path_id = qca_get_data_path_id;
+ /* Do not need to send HCI_Configure_Data_Path to configure non-HCI
+ * data transport path for QCA controllers, so set below field as NULL.
+ */
+ hdev->get_codec_config_data = NULL;
+ return 0;
+}
+
static int qca_setup(struct hci_uart *hu)
{
struct hci_dev *hdev = hu->hdev;
@@ -1969,6 +1987,10 @@ static int qca_setup(struct hci_uart *hu)
hu->hdev->set_bdaddr = qca_set_bdaddr_rome;
else
hu->hdev->set_bdaddr = qca_set_bdaddr;
+
+ if (soc_type == QCA_QCA2066)
+ qca_configure_hfp_offload(hdev);
+
qca->fw_version = le16_to_cpu(ver.patch_ver);
qca->controller_id = le16_to_cpu(ver.rom_ver);
hci_devcd_register(hdev, hci_coredump_qca, qca_dmp_hdr, NULL);
--
The Qualcomm Innovation Center
