The Lenovo Thinkpad X13s has a WCN6855 Bluetooth controller on uart2,
add this.
Signed-off-by: Steev Klimaszewski <steev@xxxxxxxx>
---
Changes since v6:
* Remove allowed-modes as they aren't needed
* Remove regulator-allow-set-load
* Set regulator-always-on because the wifi chip also uses the regulator
* cts pin uses bias-bus-hold
* Alphabetize uart2 pins
Changes since v5:
* Update patch subject
* Specify initial mode (via guess) for vreg_s1c
* Drop uart17 definition
* Rename bt_en to bt_default because configuring more than one pin
* Correct (maybe) bias configurations
* Correct cts gpio
* Split rts-tx into two nodes
* Drop incorrect link in the commit message
Changes since v4:
* Address Konrad's review comments.
Changes since v3:
* Add vreg_s1c
* Add regulators and not dead code
* Fix commit message changelog
Changes since v2:
* Remove dead code and add TODO comment
* Make dtbs_check happy with the pin definitions
.../qcom/sc8280xp-lenovo-thinkpad-x13s.dts | 78 +++++++++++++++++++
1 file changed, 78 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts b/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts
index 92d365519546..05e66505e5cc 100644
--- a/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts
+++ b/arch/arm64/boot/dts/qcom/sc8280xp-lenovo-thinkpad-x13s.dts
@@ -24,6 +24,7 @@ / {
aliases {
i2c4 = &i2c4;
i2c21 = &i2c21;
+ serial1 = &uart2;
};
wcd938x: audio-codec {
@@ -431,6 +432,14 @@ regulators-1 {
qcom,pmic-id = "c";
vdd-bob-supply = <&vreg_vph_pwr>;
+ vreg_s1c: smps1 {
+ regulator-name = "vreg_s1c";
+ regulator-min-microvolt = <1880000>;
+ regulator-max-microvolt = <1900000>;
+ regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
+ regulator-always-on;
+ };
+
vreg_l1c: ldo1 {
regulator-name = "vreg_l1c";
regulator-min-microvolt = <1800000>;
@@ -918,6 +927,32 @@ &qup0 {
status = "okay";
};
+&uart2 {
+ pinctrl-0 = <&uart2_default>;
+ pinctrl-names = "default";
+
+ status = "okay";
+
+ bluetooth {
+ compatible = "qcom,wcn6855-bt";
+
+ vddio-supply = <&vreg_s10b>;
+ vddbtcxmx-supply = <&vreg_s12b>;
+ vddrfacmn-supply = <&vreg_s12b>;
+ vddrfa0p8-supply = <&vreg_s12b>;
+ vddrfa1p2-supply = <&vreg_s11b>;
+ vddrfa1p7-supply = <&vreg_s1c>;
+
+ max-speed = <3200000>;
+
+ enable-gpios = <&tlmm 133 GPIO_ACTIVE_HIGH>;
+ swctrl-gpios = <&tlmm 132 GPIO_ACTIVE_HIGH>;
+
+ pinctrl-0 = <&bt_default>;
+ pinctrl-names = "default";
+ };
+};
+
&qup1 {
status = "okay";
};
@@ -1192,6 +1227,21 @@ hastings_reg_en: hastings-reg-en-state {
&tlmm {
gpio-reserved-ranges = <70 2>, <74 6>, <83 4>, <125 2>, <128 2>, <154 7>;
+ bt_default: bt-default-state {
+ hstp-sw-ctrl-pins {
+ pins = "gpio132";
+ function = "gpio";
+ bias-pull-down;
+ };
+
+ hstp-bt-en-pins {
+ pins = "gpio133";
+ function = "gpio";
+ drive-strength = <16>;
+ bias-disable;
+ };
+ };
+
edp_reg_en: edp-reg-en-state {
pins = "gpio25";
function = "gpio";
@@ -1213,6 +1263,34 @@ i2c4_default: i2c4-default-state {
bias-disable;
};
+ uart2_default: uart2-default-state {
+ cts-pins {
+ pins = "gpio121";
+ function = "qup2";
+ bias-bus-hold;
+ };
+
+ rts-pins {
+ pins = "gpio122";
+ function = "qup2";
+ drive-strength = <2>;
+ bias-disable;
+ };
+
+ rx-pins {
+ pins = "gpio124";
+ function = "qup2";
+ bias-pull-up;
+ };
+
+ tx-pins {
+ pins = "gpio123";
+ function = "qup2";
+ drive-strength = <2>;
+ bias-disable;
+ };
+ };
+
i2c21_default: i2c21-default-state {
pins = "gpio81", "gpio82";
function = "qup21";
--
2.39.2
