Only assign hdev->wakeup if the serial port supports wakeup. Otherwise
it will fall back to the hci_uart_wakeup or the behavior that can be
overridden before calling the hci_uart_register_device().
Signed-off-by: Zhengping Jiang <jiangzp@xxxxxxxxxx>
---
Changes in v1:
- Check serial port support before assigning wakeup callback
drivers/bluetooth/hci_qca.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 8df11016fd51..dacb6f5efd29 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1765,7 +1765,8 @@ static int qca_setup(struct hci_uart *hu)
qca_debugfs_init(hdev);
hu->hdev->hw_error = qca_hw_error;
hu->hdev->cmd_timeout = qca_cmd_timeout;
- hu->hdev->wakeup = qca_wakeup;
+ if (device_can_wakeup(hu->serdev->ctrl->dev.parent))
+ hu->hdev->wakeup = qca_wakeup;
} else if (ret == -ENOENT) {
/* No patch/nvm-config found, run with original fw/config */
set_bit(QCA_ROM_FW, &qca->flags);
--
2.38.0.413.g74048e4d9e-goog
