On 6/15/22 19:19, Pankaj Raghav wrote:
> Use bdev_is_zone_start() helper that uses generic calculation to check
> for zone alignment instead of using po2 based alignment check.
>
> Signed-off-by: Pankaj Raghav <p.raghav@xxxxxxxxxxx>
> Reviewed-by: Luis Chamberlain <mcgrof@xxxxxxxxxx>
> ---
> drivers/md/dm-table.c | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/md/dm-table.c b/drivers/md/dm-table.c
> index bd539afbf..b553cdb6d 100644
> --- a/drivers/md/dm-table.c
> +++ b/drivers/md/dm-table.c
> @@ -251,7 +251,7 @@ static int device_area_is_invalid(struct dm_target *ti, struct dm_dev *dev,
> if (bdev_is_zoned(bdev)) {
> unsigned int zone_sectors = bdev_zone_sectors(bdev);
>
> - if (start & (zone_sectors - 1)) {
> + if (blk_queue_is_zone_start(bdev_get_queue(bdev), start)) {
This is wrong. And you are changing this to the correct test in the next
patch.
> DMWARN("%s: start=%llu not aligned to h/w zone size %u of %pg",
> dm_device_name(ti->table->md),
> (unsigned long long)start,
> @@ -268,7 +268,7 @@ static int device_area_is_invalid(struct dm_target *ti, struct dm_dev *dev,
> * devices do not end up with a smaller zone in the middle of
> * the sector range.
> */
> - if (len & (zone_sectors - 1)) {
> + if (blk_queue_is_zone_start(bdev_get_queue(bdev), len)) {
> DMWARN("%s: len=%llu not aligned to h/w zone size %u of %pg",
> dm_device_name(ti->table->md),
> (unsigned long long)len,
--
Damien Le Moal
Western Digital Research
