Zone append BIOs (REQ_OP_ZONE_APPEND) always specify the start sector
of the zone to be written instead of the actual sector location to
write. The write location is determined by the device and returned to
the host upon completion of the operation. This interface, while simple
and efficient for writing into sequential zones of a zoned block
device, is incompatible with the use of sector values to calculate a
cypher block IV. All data written in a zone end up using the same IV
values corresponding to the first sectors of the zone, but read
operation will specify any sector within the zone resulting in an IV
mismatch between encryption and decryption.
To solve this problem, report to DM core that zone append operations are
not supported. This result in the zone append operations being emulated
using regular write operations.
Reported-by: Shin'ichiro Kawasaki <shinichiro.kawasaki@xxxxxxx>
Signed-off-by: Damien Le Moal <damien.lemoal@xxxxxxx>
Reviewed-by: Hannes Reinecke <hare@xxxxxxx>
---
drivers/md/dm-crypt.c | 24 +++++++++++++++++++-----
1 file changed, 19 insertions(+), 5 deletions(-)
diff --git a/drivers/md/dm-crypt.c b/drivers/md/dm-crypt.c
index f410ceee51d7..50f4cbd600d5 100644
--- a/drivers/md/dm-crypt.c
+++ b/drivers/md/dm-crypt.c
@@ -3280,14 +3280,28 @@ static int crypt_ctr(struct dm_target *ti, unsigned int argc, char **argv)
}
cc->start = tmpll;
- /*
- * For zoned block devices, we need to preserve the issuer write
- * ordering. To do so, disable write workqueues and force inline
- * encryption completion.
- */
if (bdev_is_zoned(cc->dev->bdev)) {
+ /*
+ * For zoned block devices, we need to preserve the issuer write
+ * ordering. To do so, disable write workqueues and force inline
+ * encryption completion.
+ */
set_bit(DM_CRYPT_NO_WRITE_WORKQUEUE, &cc->flags);
set_bit(DM_CRYPT_WRITE_INLINE, &cc->flags);
+
+ /*
+ * All zone append writes to a zone of a zoned block device will
+ * have the same BIO sector, the start of the zone. When the
+ * cypher IV mode uses sector values, all data targeting a
+ * zone will be encrypted using the first sector numbers of the
+ * zone. This will not result in write errors but will
+ * cause most reads to fail as reads will use the sector values
+ * for the actual data locations, resulting in IV mismatch.
+ * To avoid this problem, ask DM core to emulate zone append
+ * operations with regular writes.
+ */
+ DMDEBUG("Zone append operations will be emulated");
+ ti->emulate_zone_append = true;
}
if (crypt_integrity_aead(cc) || cc->integrity_iv_size) {
--
2.31.1
