> > > > > > On 20/11/19 9:50 PM, Alim Akhtar wrote: > > > Hi Sheebab > > > > > > On Tue, Nov 19, 2019 at 12:38 PM sheebab <sheebab@xxxxxxxxxxx> > wrote: > > >> > > >> Backup L4 attributes duirng manual hibern8 entry and restore the L4 > > >> attributes on manual hibern8 exit as per JESD220C. > > >> > > > Can you point me to the relevant section on the spec? > > > > > > > Per JESD 220C 9.4 UniPro/UFS Control Interface (Control Plane): > > > > "NOTE After exit from Hibernate all UniPro Transport Layer attributes > > (including > > L4 T_PeerDeviceID, > > > > L4 T_PeerCPortID, L4 T_ConnectionState, etc.) will be reset to their reset > values. > > All required attributes > > > > must be restored properly on both ends before communication can resume." > > > > But its not clear whether SW needs to restore these attributes or > > hardware > > > Thanks Vignesh for pointing out the spec section, yes it is not clear, one way to > confirm this is just by read L4 attributes before And after hinern8 entry/exit. > (at least in the current platform it is not being done) AFA this patch is concerns, > this looks ok to me. > @ Avri , any thought on this? Yes, it looks fine. Thanks, Avri
