Properly plumb out EOPNOTSUPP from loop driver operations, which may
get returned when for instance a discard operation is attempted but not
supported by the underlying block device. Before this change, everything
was reported in the log as an I/O error, which is scary and not
helpful in debugging.
Signed-off-by: Evan Green <evgreen@xxxxxxxxxxxx>
---
Changes in v7:
- Use errno_to_blk_status() (Christoph)
Changes in v6:
- Updated tags
Changes in v5: None
Changes in v4: None
Changes in v3:
- Updated tags
Changes in v2:
- Unnested error if statement (Bart)
drivers/block/loop.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/block/loop.c b/drivers/block/loop.c
index ef6e251857c8..6a9fe1f9fe84 100644
--- a/drivers/block/loop.c
+++ b/drivers/block/loop.c
@@ -461,7 +461,7 @@ static void lo_complete_rq(struct request *rq)
if (!cmd->use_aio || cmd->ret < 0 || cmd->ret == blk_rq_bytes(rq) ||
req_op(rq) != REQ_OP_READ) {
if (cmd->ret < 0)
- ret = BLK_STS_IOERR;
+ ret = errno_to_blk_status(cmd->ret);
goto end_io;
}
@@ -1950,7 +1950,10 @@ static void loop_handle_cmd(struct loop_cmd *cmd)
failed:
/* complete non-aio request */
if (!cmd->use_aio || ret) {
- cmd->ret = ret ? -EIO : 0;
+ if (ret == -EOPNOTSUPP)
+ cmd->ret = ret;
+ else
+ cmd->ret = ret ? -EIO : 0;
blk_mq_complete_request(rq);
}
}
--
2.21.0
