On Tue, Jul 03, 2018 at 12:50:10PM -0700, Omar Sandoval wrote: > On Tue, Jul 03, 2018 at 12:49:13PM -0700, Omar Sandoval wrote: > > On Fri, Jun 29, 2018 at 09:13:53AM -0700, Bart Van Assche wrote: > > > On 06/28/18 16:43, Omar Sandoval wrote: > > > > On Wed, Jun 27, 2018 at 02:49:08PM -0700, Bart Van Assche wrote: > > > > [ ... ] > > > > srp/002 (File I/O on top of multipath concurrently with logout and login (mq)) [failed] > > > > runtime 6.680s ... 6.640s > > > > --- tests/srp/002.out 2018-06-28 15:18:36.537169282 -0700 > > > > +++ results/nodev/srp/002.out.bad 2018-06-28 16:21:59.930603931 -0700 > > > > @@ -3,5 +3,4 @@ > > > > Unloaded the rdma_rxe kernel module > > > > Configured SRP target driver > > > > Unloaded the ib_srp kernel module > > > > -Unloaded the ib_srpt kernel module > > > > -Unloaded the rdma_rxe kernel module > > > > +/dev/disk/by-id/dm-uuid-mpath-3600140572616d6469736b31000000000: not found > > > > > > > > And everything else fails like srp/002. > > > > > > I think that indicates a problem with the multipathing software on your > > > setup. Was multipathd running? Had the proper multipath configuration > > > (/etc/multipath.conf) been provided? Was multipathing enabled in the kernel > > > config? > > > > Ah, the README says /etc/multipathd.conf. Fixing it to multipath.conf > > didn't work, either, though. > > Hit send too early. multipathd is running, but I did find this in my > dmesg: > > [ 1844.347561] multipath[6558]: segfault at 100 ip 00007fbb7cda51e6 sp 00007fffe9241798 error 4 in libc-2.27.so[7fbb7cd0e000+1b3000] > > I'll look into that. Alright, I installed multipath-tools from source and the segfaults are gone, but I still don't get these symlinks. Instead, they show up as /dev/disk/by-id/scsi-3600140572616d6469736b32000000000 Any ideas?
