[PATCH V3 1/8] scsi: hpsa: fix selection of reply queue

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



>From 84676c1f21 (genirq/affinity: assign vectors to all possible CPUs),
one msix vector can be created without any online CPU mapped, then one
command's completion may not be notified.

This patch setups mapping between cpu and reply queue according to irq
affinity info retrived by pci_irq_get_affinity(), and uses this mapping
table to choose reply queue for queuing one command.

Then the chosen reply queue has to be active, and fixes IO hang caused
by using inactive reply queue which doesn't have any online CPU mapped.

Cc: Hannes Reinecke <hare@xxxxxxx>
Cc: Arun Easi <arun.easi@xxxxxxxxxx>
Cc: "Martin K. Petersen" <martin.petersen@xxxxxxxxxx>,
Cc: James Bottomley <james.bottomley@xxxxxxxxxxxxxxxxxxxxx>,
Cc: Christoph Hellwig <hch@xxxxxx>,
Cc: Don Brace <don.brace@xxxxxxxxxxxxx>
Cc: Kashyap Desai <kashyap.desai@xxxxxxxxxxxx>
Cc: Peter Rivera <peter.rivera@xxxxxxxxxxxx>
Cc: Laurence Oberman <loberman@xxxxxxxxxx>
Cc: Meelis Roos <mroos@xxxxxxxx>
Fixes: 84676c1f21e8 ("genirq/affinity: assign vectors to all possible CPUs")
Signed-off-by: Ming Lei <ming.lei@xxxxxxxxxx>
---
 drivers/scsi/hpsa.c | 73 +++++++++++++++++++++++++++++++++++++++--------------
 drivers/scsi/hpsa.h |  1 +
 2 files changed, 55 insertions(+), 19 deletions(-)

diff --git a/drivers/scsi/hpsa.c b/drivers/scsi/hpsa.c
index 5293e6827ce5..3a9eca163db8 100644
--- a/drivers/scsi/hpsa.c
+++ b/drivers/scsi/hpsa.c
@@ -1045,11 +1045,7 @@ static void set_performant_mode(struct ctlr_info *h, struct CommandList *c,
 		c->busaddr |= 1 | (h->blockFetchTable[c->Header.SGList] << 1);
 		if (unlikely(!h->msix_vectors))
 			return;
-		if (likely(reply_queue == DEFAULT_REPLY_QUEUE))
-			c->Header.ReplyQueue =
-				raw_smp_processor_id() % h->nreply_queues;
-		else
-			c->Header.ReplyQueue = reply_queue % h->nreply_queues;
+		c->Header.ReplyQueue = reply_queue;
 	}
 }
 
@@ -1063,10 +1059,7 @@ static void set_ioaccel1_performant_mode(struct ctlr_info *h,
 	 * Tell the controller to post the reply to the queue for this
 	 * processor.  This seems to give the best I/O throughput.
 	 */
-	if (likely(reply_queue == DEFAULT_REPLY_QUEUE))
-		cp->ReplyQueue = smp_processor_id() % h->nreply_queues;
-	else
-		cp->ReplyQueue = reply_queue % h->nreply_queues;
+	cp->ReplyQueue = reply_queue;
 	/*
 	 * Set the bits in the address sent down to include:
 	 *  - performant mode bit (bit 0)
@@ -1087,10 +1080,7 @@ static void set_ioaccel2_tmf_performant_mode(struct ctlr_info *h,
 	/* Tell the controller to post the reply to the queue for this
 	 * processor.  This seems to give the best I/O throughput.
 	 */
-	if (likely(reply_queue == DEFAULT_REPLY_QUEUE))
-		cp->reply_queue = smp_processor_id() % h->nreply_queues;
-	else
-		cp->reply_queue = reply_queue % h->nreply_queues;
+	cp->reply_queue = reply_queue;
 	/* Set the bits in the address sent down to include:
 	 *  - performant mode bit not used in ioaccel mode 2
 	 *  - pull count (bits 0-3)
@@ -1109,10 +1099,7 @@ static void set_ioaccel2_performant_mode(struct ctlr_info *h,
 	 * Tell the controller to post the reply to the queue for this
 	 * processor.  This seems to give the best I/O throughput.
 	 */
-	if (likely(reply_queue == DEFAULT_REPLY_QUEUE))
-		cp->reply_queue = smp_processor_id() % h->nreply_queues;
-	else
-		cp->reply_queue = reply_queue % h->nreply_queues;
+	cp->reply_queue = reply_queue;
 	/*
 	 * Set the bits in the address sent down to include:
 	 *  - performant mode bit not used in ioaccel mode 2
@@ -1157,6 +1144,8 @@ static void __enqueue_cmd_and_start_io(struct ctlr_info *h,
 {
 	dial_down_lockup_detection_during_fw_flash(h, c);
 	atomic_inc(&h->commands_outstanding);
+
+	reply_queue = h->reply_map[raw_smp_processor_id()];
 	switch (c->cmd_type) {
 	case CMD_IOACCEL1:
 		set_ioaccel1_performant_mode(h, c, reply_queue);
@@ -7376,6 +7365,26 @@ static void hpsa_disable_interrupt_mode(struct ctlr_info *h)
 	h->msix_vectors = 0;
 }
 
+static void hpsa_setup_reply_map(struct ctlr_info *h)
+{
+	const struct cpumask *mask;
+	unsigned int queue, cpu;
+
+	for (queue = 0; queue < h->msix_vectors; queue++) {
+		mask = pci_irq_get_affinity(h->pdev, queue);
+		if (!mask)
+			goto fallback;
+
+		for_each_cpu(cpu, mask)
+			h->reply_map[cpu] = queue;
+	}
+	return;
+
+fallback:
+	for_each_possible_cpu(cpu)
+		h->reply_map[cpu] = 0;
+}
+
 /* If MSI/MSI-X is supported by the kernel we will try to enable it on
  * controllers that are capable. If not, we use legacy INTx mode.
  */
@@ -7771,6 +7780,10 @@ static int hpsa_pci_init(struct ctlr_info *h)
 	err = hpsa_interrupt_mode(h);
 	if (err)
 		goto clean1;
+
+	/* setup mapping between CPU and reply queue */
+	hpsa_setup_reply_map(h);
+
 	err = hpsa_pci_find_memory_BAR(h->pdev, &h->paddr);
 	if (err)
 		goto clean2;	/* intmode+region, pci */
@@ -8480,6 +8493,28 @@ static struct workqueue_struct *hpsa_create_controller_wq(struct ctlr_info *h,
 	return wq;
 }
 
+static void hpda_free_ctlr_info(struct ctlr_info *h)
+{
+	kfree(h->reply_map);
+	kfree(h);
+}
+
+static struct ctlr_info *hpda_alloc_ctlr_info(void)
+{
+	struct ctlr_info *h;
+
+	h = kzalloc(sizeof(*h), GFP_KERNEL);
+	if (!h)
+		return NULL;
+
+	h->reply_map = kzalloc(sizeof(*h->reply_map) * nr_cpu_ids, GFP_KERNEL);
+	if (!h->reply_map) {
+		kfree(h);
+		return NULL;
+	}
+	return h;
+}
+
 static int hpsa_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 {
 	int dac, rc;
@@ -8517,7 +8552,7 @@ static int hpsa_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 	 * the driver.  See comments in hpsa.h for more info.
 	 */
 	BUILD_BUG_ON(sizeof(struct CommandList) % COMMANDLIST_ALIGNMENT);
-	h = kzalloc(sizeof(*h), GFP_KERNEL);
+	h = hpda_alloc_ctlr_info();
 	if (!h) {
 		dev_err(&pdev->dev, "Failed to allocate controller head\n");
 		return -ENOMEM;
@@ -8916,7 +8951,7 @@ static void hpsa_remove_one(struct pci_dev *pdev)
 	h->lockup_detected = NULL;			/* init_one 2 */
 	/* (void) pci_disable_pcie_error_reporting(pdev); */	/* init_one 1 */
 
-	kfree(h);					/* init_one 1 */
+	hpda_free_ctlr_info(h);				/* init_one 1 */
 }
 
 static int hpsa_suspend(__attribute__((unused)) struct pci_dev *pdev,
diff --git a/drivers/scsi/hpsa.h b/drivers/scsi/hpsa.h
index 018f980a701c..fb9f5e7f8209 100644
--- a/drivers/scsi/hpsa.h
+++ b/drivers/scsi/hpsa.h
@@ -158,6 +158,7 @@ struct bmic_controller_parameters {
 #pragma pack()
 
 struct ctlr_info {
+	unsigned int *reply_map;
 	int	ctlr;
 	char	devname[8];
 	char    *product_name;
-- 
2.9.5




[Index of Archives]     [Linux RAID]     [Linux SCSI]     [Linux ATA RAID]     [IDE]     [Linux Wireless]     [Linux Kernel]     [ATH6KL]     [Linux Bluetooth]     [Linux Netdev]     [Kernel Newbies]     [Security]     [Git]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Device Mapper]

  Powered by Linux