On Mon, Mar 04, 2024 at 01:04:26PM +0000, John Garry wrote:
> Support providing info on atomic write unit min and max for an inode.
>
> For simplicity, currently we limit the min at the FS block size, but a
> lower limit could be supported in future. This is required by iomap
> DIO.
>
> The atomic write unit min and max is limited by the guaranteed extent
> alignment for the inode.
>
> Signed-off-by: John Garry <john.g.garry@xxxxxxxxxx>
> ---
> fs/xfs/xfs_iops.c | 38 ++++++++++++++++++++++++++++++++++++++
> 1 file changed, 38 insertions(+)
>
> diff --git a/fs/xfs/xfs_iops.c b/fs/xfs/xfs_iops.c
> index a0d77f5f512e..6316448083d2 100644
> --- a/fs/xfs/xfs_iops.c
> +++ b/fs/xfs/xfs_iops.c
> @@ -546,6 +546,37 @@ xfs_stat_blksize(
> return PAGE_SIZE;
> }
>
> +static void
> +xfs_get_atomic_write_attr(
> + struct xfs_inode *ip,
> + unsigned int *unit_min,
> + unsigned int *unit_max)
> +{
> + xfs_extlen_t extsz = xfs_get_extsz(ip);
> + struct xfs_buftarg *target = xfs_inode_buftarg(ip);
> + struct block_device *bdev = target->bt_bdev;
> + struct request_queue *q = bdev->bd_queue;
> + struct xfs_mount *mp = ip->i_mount;
> + struct xfs_sb *sbp = &mp->m_sb;
> + unsigned int awu_min, awu_max;
> + unsigned int extsz_bytes = XFS_FSB_TO_B(mp, extsz);
> +
> + awu_min = queue_atomic_write_unit_min_bytes(q);
> + awu_max = queue_atomic_write_unit_max_bytes(q);
We really should be storing these in the xfs_buftarg at mount time,
like we do logical and physical sector sizes. Similar to sector
sizes, they *must not change* once the filesystem has been created
on the device, let alone during an active mount. The whole point of
the xfs_buftarg is to store the information the filesystem
needs to do IO to the underlying block device so we don't have to
chase pointers deep into the block device whenever we need to use
static geometry information.....
> + if (sbp->sb_blocksize > awu_max || awu_min > sbp->sb_blocksize ||
> + !xfs_inode_atomicwrites(ip)) {
> + *unit_min = 0;
> + *unit_max = 0;
> + return;
> + }
Again, this is comparing static geometry - if the block size doesn't
allow atomic writes, then the inode flag should never be set. i.e.
geometry is checked when configuring atomic writes, not in every
place we need to check if atomic writes are supported. Hence this
should simply be:
if (!xfs_inode_has_atomic_writes(ip)) {
*unit_min = 0;
*unit_max = 0;
return;
}
before we even look at the xfs_buftarg to get the supported min/max
values for the given device.
Cheers,
Dave.
--
Dave Chinner
david@xxxxxxxxxxxxx
