I do not know at what point people have wanted to have a system with MMC/SD support without the block layer. We are anyway now so tightly integrated with the block layer that this is onlt teoretical and it makes no sense to have the block layer interface as optional. Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> --- drivers/mmc/core/Kconfig | 12 ------------ drivers/mmc/core/Makefile | 5 ++--- 2 files changed, 2 insertions(+), 15 deletions(-) diff --git a/drivers/mmc/core/Kconfig b/drivers/mmc/core/Kconfig index cdfa8520a4b1..2920bc4351ed 100644 --- a/drivers/mmc/core/Kconfig +++ b/drivers/mmc/core/Kconfig @@ -23,19 +23,8 @@ config PWRSEQ_SIMPLE This driver can also be built as a module. If so, the module will be called pwrseq_simple. -config MMC_BLOCK - tristate "MMC block device driver" - depends on BLOCK - default y - help - Say Y here to enable the MMC block device driver support. - This provides a block device driver, which you can use to - mount the filesystem. Almost everyone wishing MMC support - should say Y or M here. - config MMC_BLOCK_MINORS int "Number of minors per block device" - depends on MMC_BLOCK range 4 256 default 8 help @@ -53,7 +42,6 @@ config MMC_BLOCK_MINORS config MMC_BLOCK_BOUNCE bool "Use bounce buffer for simple hosts" - depends on MMC_BLOCK default y help SD/MMC is a high latency protocol where it is crucial to diff --git a/drivers/mmc/core/Makefile b/drivers/mmc/core/Makefile index b2a257dc644f..42f0d781d911 100644 --- a/drivers/mmc/core/Makefile +++ b/drivers/mmc/core/Makefile @@ -7,12 +7,11 @@ mmc_core-y := core.o bus.o host.o \ mmc.o mmc_ops.o sd.o sd_ops.o \ sdio.o sdio_ops.o sdio_bus.o \ sdio_cis.o sdio_io.o sdio_irq.o \ - quirks.o slot-gpio.o + quirks.o slot-gpio.o \ + block.o queue.o mmc_core-$(CONFIG_OF) += pwrseq.o obj-$(CONFIG_PWRSEQ_SIMPLE) += pwrseq_simple.o obj-$(CONFIG_PWRSEQ_EMMC) += pwrseq_emmc.o mmc_core-$(CONFIG_DEBUG_FS) += debugfs.o -obj-$(CONFIG_MMC_BLOCK) += mmc_block.o -mmc_block-objs := block.o queue.o obj-$(CONFIG_MMC_TEST) += mmc_test.o obj-$(CONFIG_SDIO_UART) += sdio_uart.o -- 2.9.3
