On 4 August 2014 at 18:52, Ivan K <ivan_521521@xxxxxxxxx> wrote: > I have successfully recorded from my > USBDualTubePre microphone preamp using the S/PDIF > into my M-Audio 2496. I used mhWaveEdit. > > The issue was that qjackctl was displaying the > Readable Clients/Output Ports and > Writable Clients/Input Ports of my _motherboard_ > audio, not my M-Audio 2496. > > A recent off list reply coached me to set the > correct device in Qjackctl with "Setup | Interface | >". > > Early on, Len Ovens informed me that the S/PDIF > inputs of the ice1712 are 9 and 10. > > And of course, using envy24control to set "Master clock" > to s/pdif rather than a sample rate was required as well. > > And so, thank you to all who responded! Thanks for the discussion and your conclusions. I'm about to try to transfer the content of an audio DAT tape using a Panasonic DAT deck via the S/PDIF i/o on my Delta 1010 audio interface. You all may have just saved me some headaches. FWIW, I'll be attempting this using Ardour, which plays quite nicely with JACK[12], and plays quite nicely on my system in general. But, S/PDIF is new to me. Cheerio.... -- Kevin _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user
