On May 9, 2014 12:44:00 AM Jörn Nettingsmeier wrote: > On 05/08/2014 09:30 PM, Jonathan E Brickman wrote: > > AC power ground lifts sometimes have helped, sometimes > > There is no such thing as an AC power ground lift. The correct term, and > please don't take it personally, is _criminal_ _incompetence_. > > Calling it anything else should be avoided, because that makes it sound > like something clever which the pros do. Rest assured, they don't. > > You _always_ want your case grounded, unless you have double insulation, > and in that case, your power plug is two-pin only to begin with. > > Any artist I catch on any stage I manage with tape across their ground > connectors can clock off early, with no show. > > The only responsible and reasonable thing to do is a _signal_ ground > lift. Period. Although it might not relate directly to the OP's question, since the safety topic came up I would like to relate a story about one reason you should never remove power ground pins and make sure your outlets are grounded: Some relevant info: http://en.wikipedia.org/wiki/Cheater_plug Grounding is important not only for day-to-day usage, but in case of unexpected catastrophic failure. So this high-power powered PA speaker decides to SMOKE in the middle of a practice. Diagnosis, and a theory of what caused it: A component on the Switch Mode Power Supply board's +15V rail short-circuited. The short still exists, haven't tried to find the component yet, because: It appears that, at the exact moment of the short, the SPMS wanted to dump a lot of current into the chassis ground while things went haywire for a moment and the driver was still running and things shut down and caps discharged and so on. But here, the Input Board, which is fed by the +/- 15V power rails, was DESTROYED. The tops of all ten or so 8-pin op-amp ICs were completely BURNT and CHARRED open. More tellingly, in this model there's a 10-ohm surface-mount ground RESISTOR on the Input Board, connecting INPUT signal ground to CHASSIS ground. The resistor, and the circuit board area, were completely BURNT and CHARRED. (A mixer was connected to this PA, on the same AC circuit) Conclusion: I could only conclude there was no CHASSIS (AC) ground, or it was breached by a bad or loose cord. If AC ground had been intact, the catastrophic current would have been dumped into the AC ground and there would have been little or NO potential difference across the 10-ohm ground resistor to cause THAT amount of damage to it. The resulting wackiness in voltage swings could be what destroyed all those Input Board op-amp ICs. So the current wanted to flow into the AC ground but instead took the easiest path it could - through the surface-mount 10-ohm ground resistor, back through the INPUT cable and into the MIXER ground. (I checked: The mixer has no such resistor. Signal ground = chassis ground. The mixer still works. Still, I advised the owner to change his input cable.) Tim. _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user
