On Mon, August 20, 2012 3:45 am, Mac wrote: > So far my poking around on the net indicates that dbus service between > pulse and jack are involved. (if you uncheck the start dbus in > qjackctrl only the firewire source/sinks show up). > > The pulse source/sinks are provided by pulseaudio-module-jack. > > What control over how things are named or created is still > unknown...to me at least. Ok I have looked at what I can find of on the pulse-jack bridge. At the least it should be possible to turn the auto connect feature off. In the file: /etc/pulse/default.pa change the line: load-module module-jackdbus-detect to: load-module module-jackdbus-detect connect=no This file will need to be edited sudo BTW... then do the command pulseaudio --kill so pulse respawns and picks up the new config. Now when starting jack pulse and system will show up but with no connections. manually connect system/capture to PulseAudio Jack Source/front-left and capture_1 to front-right and use qjackctl's patchbay to save this configuration so you can reconnect this way easily. (even automatically at jackstart from qjackctl). Unfortunately, using the save current setup option in patchbay does not work. It seems the patch bay only saves whole device connects. So you have to create four new dummy devices in the patch bay (two on either side with add. That have only ports each. The order of ports in these defines is how they will connect. Or just leave it unconnected and connect manually as needed. I haven't played with this much... just enough to confirm I could get stereo connects and that I could switch left and right. The pulse source and sink modules have command-line options to set them to only 2 outputs (I wish that was the default) but because they are started by module-jackdbus-detect, there seems to be no where to put these options. However, if you normally only have FW as your only output and so have Jack always running it may be possible to hard start the source and sink instead of the detect module. Then the options could be set. Still no connect as it would still choose 1 and 2 instead of 0 and 1. I am hearing that the FW stack is being moved to ALSA (or added?) but I don't know how far that is away from actually happening. -- Len Ovens www.OvenWerks.net _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user
