On Tue, May 10, 2011 at 08:07:48AM -0700, menno wrote: > i'd like to get information on Aeolus from Fons Adriaensen, the link to his page seems to be dead. > I'd like to know about how to access and use the stops with midi. > Is there a good doc somewhere? The website is available on <http://kokkinizita.linuxaudio.org>. The README in the source distribution explains how to control the stops using MIDI. I copy the relevant section below. 6. Midi control of stop buttons ------------------------------- The protocol uses one controller number. The default is #98, but you can change this in global.h. The message is accepted only on channels enabled for control in the midi matrix. The value is interpreted as follows: v = 01mm0ggg This type of messages (bit 6 set) selects a group, and either resets all stops in that group or sets the mode for the second form below. mm = mode. This can be: 00 disabled, also resets all elements in the group. 01 set off 10 set on 11 toggle ggg = group, one of the button groups as defined in the instrument definition. In the GUI groups start at the top, the first one (for division III) being group #0. The values of mm and ggg are stored and need not be repeated unless they change. v = 000bbbbb According to the current state of mode, this command switches a stop on or off, or toggles its state, or does nothing at all. bbbbb = button index within the group. Buttons are numbered left to right, top to bottom within each group. The first one is #0. Ciao, -- FA _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user
