On Sunday 13 July 2008 23:58:19 Emanuel Rumpf wrote: > things to do additionally > --------------------------------------------------------------------------- >--- > > > enable realtime clock > ---------------------- > > for the realtime clock to work, you've got to load these modules: > modprobe rtc_core > modprobe rtc_cmos > > you should then have a device > /dev/rtc0 I have /dev/rtc from previous > > then change the max-user-frequency of rtc (default is only 64): > echo 2048 > /sys/class/rtc/rtc0/max_user_freq I have this set to 1024 (kernel hz?) in /etc/sysctl.conf. > test: > cat /sys/class/rtc/rtc0/max_user_freq > > > and maybe of hpet as well (?) > echo 2048 > /proc/sys/dev/hpet/max-user-freq > (Is hpet emulated by rtc ?) There are hpet source files in the kernel sources and among them an hpet/emulate.rtc.h. No particular hpet.ko was built, however. There is a /usr/src/linux-2.6.25.8/Documentation/hpet.txt which says that this is a REPLACEMENT for the rtc stuff and the first two of its 32 timers will stand in for the rtc. So it would seem one or the other. > --------------------------------------------------------------------------- >--- > > > > set realtime priorities > ----------------------- > > install scheduling tools (/usr/bin/chrt) > apt-get install schedutils This one threatened to remove some stuff > or > apt-get install schedtool This one was clean. > > > install,setup and run the rtirq script by Rui Nuno Capela > download: > wget http://www.rncbc.org/jack/rtirq-20071012.tar.gz Got it, copied the files to places and my startup stuff to run it. So will give everything a try out. The kernel runs fine. Debian's nvidia built and works OK. One caveat is that hal kicks out all the dma and 32-bit disk accesses but they can be immediately set back so I put that in my startup stuff as well. _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/mailman/listinfo/linux-audio-user
