On Wed, 30 Aug 2006, Spencer Russell wrote:
Do you have JACK set to playback only?
I did, yes, since I'm presently mixing already recorded tracks.
If I recall, I had this problem with saved sessions. A new session would work, I think, but once I saved it and opened it again, I couldn't add a bus if JACK was set to playback only. If you set JACK to full duplex the problem should go away.
Indeed it did! Thank you _very_ much!
I guess not a lot of people run Ardour with JACK on playback only.
Could be. Perhaps I don't need to change Jack's configuration based on whether I'm tracking or mixing? (I do have a few saved configurations, for example, because some projects I'm working on were recorded by others with a different sample rate than I normally like to work with, and it's a lot easier, and sounds better at least on my system, to just adjust Jack than it is to resample the tracks.) Alright, then ... on with the mix! :-) -- ---------------------------------------------------------------------- Sylvain Robitaille syl@xxxxxxxxxxxxxxxxxx Major in Electroacoustic Studies Concordia University Faculty of Fine Arts / Music Department Montreal, Quebec, Canada ----------------------------------------------------------------------