On Mon, 1 May 2006 03:08:40 -0700 "Rich E" <reakinator@xxxxxxxxx> wrote: > I've been running a RME hdsp multiface2 with pci on the PlanetCCRMA > low latency kernel for a couple months now, and while it runs nice, I > can't get the latency in Pd below about 20ms. If I set anything > lower, there are dropouts. I've messed around with the Pd settings a > bit, but I haven't touched any system settings because I'm confused by > the stats of my soundcard. lspci -v tells me the hdsp card is on irq > 187 and it has 255ms latency. According to all the documentation I > have seen (which is all at least a couple years old, most the time > around 2000), neither of these numbers should be possible. I think > the low latency kernel, with "realtime preemption patch by Ingo > Molnar", is messing with these, but I really don't know. > > Does anyone know anything about what the hdsp's irq and latency > settings should be on a realtime linux system? Forget what lspci tells you about latency. It's not a millisecond number. It should actually not interest you in any way. Anyways, i suppose you use a system with a local APIC. That explains the high interrupt numbers. Contrary to the previous XT-PIC older systems had, and which assigned irq numbers in the range of 0-15 [with some oddnesses], the local APIC uses a very different scheme. The old XT-PIC scheme was severely limited due to the small number of irq's available for devices. Anyways, you might want to read around on the webpage in my signature. It gives some clues on how to setup a system with a -rt kernel. To inspect your priority setup i'd recommend htop which can sort for priority. Regards, Flo P.S.: I don't know how well jack'ified Pd is. I never tried it. Maybe it simply sucks ;) Do you use it with jack at all? If you do run it with the ALSA backend, does it have a way to set its priority? -- Palimm Palimm! http://tapas.affenbande.org
