Hi Peder, --- Peder Hedlund <peder@xxxxxxxxxxxxxx> wrote: > > Bug (?) : > I have a 24 bit stereo track in Ardour connected to > Jamin and returned > to another stero track. When the mastering is done I > export the mastered > track to 16 bit wav. Everything works, but after > Ardour has exported 100% > (and before closing the export screen) it's dead for > 15-45 secs. > During this, 'top' shows 85-95% CPU usage for Jamin. > If I close Jamin before exporting, Ardour responds > directly. I see this too. Until someone fixes it, just let it run it's course. > Question: > I have an Ardour session with 17 tracks that have > EQ, compression and > the occasional effect pre-fader, a phaser on a > pre-fader send bus and a > stereo reverb pre-fader on the master bus. > If I route the master bus to Jamin and back in on a > stereo track > the Jamin output sounds fine, but the stereo track > ends up with none of > the effects. > Is it impossible to do a multitrack mastering with > the effects intact > or am I doing something wrong? Ardour; Options, Miscelaneous, Run Plugins While Recording. There was a point when I thought this was a bug. I installed Timemachine and started recording mixes into it. dah! ron > HW/SW specs: AMD AthlonXP 1200+, 512MB RAM, SB > Live!, kernel 2.6.12 > rlimits, jack in RT mode. Ardour CVS from Aug 31 and > Jamin CVS from > mid/end July. > > > Regards, > > Peder > ______________________________________________________ Yahoo! for Good Watch the Hurricane Katrina Shelter From The Storm concert http://advision.webevents.yahoo.com/shelter
