On Wed, Feb 02, 2005 at 04:12:39PM +1000, vector wrote: > Hi > newbie > Just grasping the ins and outs of jack > basic sound blaster card > tone present on line in > qjackctl shows capture_1, .. _2. > I can remove the route of capture_1 etc to things like ardour by > disconnecting it in qjackctl as expected. > however I cant stop the line input from being "mirrored" on the cards > output. > gnomes volume control ..line slider allows me to adjust the volume. > (like a pre fader) but no matter what i disconnect in jack the tone on > line input also comes out of the cards output. I'm not sure how the architecture of all this is done (I'm still learning) but I found that I have to mute the line to make it silent. I did that in alsamixer. Just go to the "line" and press "m". regards, - Bengan -------------------------------------------------------------- - KTHNOC/SUNET/NORDUnet | http://www.sunet.se/~bengan | +46 8 7906586 -
