Hi! [DISCLAIMER] I've only done a (relatively) limited amount of recording. On the other hand, I have studied many recordings, and have read a lot about the subject... I'm slowly learning what works in practice. [/DISCLAIMER] In general, these are the steps which I would try to follow: 1. Try to make the raw acoustic sound as good as possible, thinking about the acoustics of the room, and the creation of the sound itself. 2. Pay a lot of attention to microphone choice, placement, and technique. 3. Try to make sure no other sounds on the recording interfere with the frequencies of the vocal. Apply parametric EQ where necessary, to cut appropriate frequencies. I did have a nice reference table of typical frequency ranges for a list of instruments, but I have mislaid it. The same information is probably freely available online. Play with the EQ until happy. 4. Maybe apply a little reverb, remembering that it often helps to apply the same reverb to all the sounds, as it lends a certain coherence to the mix. It is natural for all of the instruments to be performed in the same room in real life, I think. 5. That's about it I think. Lots of people would also use some compression. This might help smooth out uneven dynamics, and possibly make the recording more polished. Personally, I just try to get the original performance to be good. In my opinion, a decent musician should be able to control the dynamics of his playing. Dynamics are an integral part of music. Just keep playing with plugins, and I expect you'll find what you want! I find it interesting to bypass all my plugins at some point - and listen to the raw sound again. I often find that I prefer it. Maybe that's just because I'm not experienced enough to use them yet! Regards Michael
